Installing The Turbocharger - ABB HT843754 Operation Manual

Operation Manual / TPL69-A10 / -A30 ... TPL77-A10 / -A30
7 Removal and installation / 7.3 Installing the turbocharger

7.3 Installing the turbocharger

© Copyright 2018 . All rights reserved.
Remove cover from oil connection.
u
Inspect lifting gear.
u
Fasten separate lifting gear to each of two ribs on bearing casing
u
provided for this purpose.
CAUTION
Oil orifice plates
An orifice plate for adjusting the oil pressure is fitted in each of the two
oil inlet channels in the bearing casing. When the cartridge group, the
bearing casing or the turbocharger is fitted to the engine, it must be
ensured that the orifice plates that are specified for the turbocharger
have been installed in the two oil inlet channels.
Check correct installation of oil orifice plates.
u
Adapt turbocharger to suit engine.
u
Tighten fixing screws at foot in accordance with engine builder's in-
u
structions.
Fasten gas, air and oil lines in accordance with engine builder's in-
u
structions.
Version with compressor wheel cooling system
Fit air supply line. (See also chapter Preliminary remarks / Layout and
u
functioning.)
Refit removed parts of insulation.
u
Plug in cable connector on speed sensor.
u
HZTL2481_EN Revision C May 2018