Advertisement
Quick Links
CANYON FURNITURE COMPANY.
STEP BUNK BED ASSEMBLY INSTRUCTIONS ( 90-160 )
LIST OF CONTENTS
B
A
UPPER BED END BOX ( 90-705 ) FIG.1
A.- (1) UPPER BED END
B.- (2) METAL DOWEL PINS
FIG. 1
3 DRAWER STUDENT LOFT DESK BOX ( 90-710 ) FIG.2
C.- (1) 3 DRAWER STUDENT LOFT DESK
OR 5 DRAWER STUDENT LOFT CHEST BOX ( 90-711 )
D.- (1) 5 DRAWER STUDENT LOFT CHEST
D
STEP BUNK BED HEADBOADR BOX ( 90-160 ) FIG.3
E.- (1) STEP BUNK BED HEADBOARD
6 PCS SIDE RAILS BOX ( 90-730 ) FIG.4
F.- (4) SIDE RAILS
G.- (2) GUARD RAILS
H.- (7) 38 7/8" SLATS
I.- (24) 4" HEX BOLTS
J.- (24) 5/8" CROSS DOWEL NUTS
K.- (24) FLAT WASHERS
C
FIG. 2
L.- (1) 4MM HEX KEY
M.- (14) 1 1/4" SCREWS
G
CASTER BED BOX ( 90-709,90-707 ) FIG.5
N.- (1) HEADBOARD
O.- (1) FOOTBOARD
P.- (3) 53 7/8" SLATS
F
M.- (6) 1 1/4" SCREWS
J
Q.- (4) CASTERS
R.- (4) CASTERS SOCKETS
I
E
H
K
FIG. 4
M
L
P
FIG. 5
N
FIG. 3
R
O
Q
REV 02 09/30/09
PAGE 1 OF 5
KIS00949
Advertisement
Related Manuals for Canyon 90-160
Summary of Contents for Canyon 90-160
- Page 1 OR 5 DRAWER STUDENT LOFT CHEST BOX ( 90-711 ) D.- (1) 5 DRAWER STUDENT LOFT CHEST STEP BUNK BED HEADBOADR BOX ( 90-160 ) FIG.3 E.- (1) STEP BUNK BED HEADBOARD 6 PCS SIDE RAILS BOX ( 90-730 ) FIG.4 F.- (4) SIDE RAILS...
-
Page 2: Front Part
CANYON FURNITURE COMPANY. 1.-PROCEED TO ASSEMBLE THIS STEP BUNK BED,FIRST CHOOSING THE CONFIGURATION THAT FITS YOUR ROOM,LEFT OR RIGHT SEE FIG.9,IF LEFT GO TO STEP # 3 OR RIGHT GO TO STEP # 2. 2.- CHANGE SAFETY GRILL THAT IS FACTORY INSTALLED IN LEFT SIDE TO THE RIGHT SIDE,USING A PHILLIPS SCREWDRIVER (NOT INCLUDED) REMOVE SCREWS FROM STEP (SAVE THE SCREWS TO RE-ATTACH THE GRILL TO RIGHT SIDE), THEN INSTALL GRILL THE RIGHT SIDE, SEE FIG.9... - Page 3 CANYON FURNITURE COMPANY. 1.- ASSEMBLE FULL BED, USING TWO SIDE RAILS (F) ONE HEADBOARD (N), ONE FOOTBOARD (O),THE SAME WAY AS THE TOP SIDE RAILS SEE FIG.7 AND THREE SLATS (P), ONE SLAT IN BOTH HEADBOARD&FOOTBOARD ENDS AND PUSH SLATS AGAINST THE BED END POST (FIG.B), THEN PLACE ONE SLAT IN THE MIDDLE AT EQUAL DISTANCE FROM THE END SLATS AND SECURE WITH 1 1/4"...
- Page 4 MATTRESS ALONE,A SLAT PACK OR A BUNKIE BOARD IS REQUIRED FOR PROPER SAFETY. ( NOT INCLUDED ) REPLACEMENT PARTS REPLACEMENT PARTS, INCLUDING ADDITIONAL GUARDRAILS, MAY BE OBTAINED FROM ANY OF OUR CANYON FURNITURE COMPANY DEALERS. REV 02 09/30/09 PAGE 4 OF 5 KIS00949...
- Page 5 DRAWERS ARE SECURED NOTE : THE DRAWERS ON THE STEP BED HAVE BEEN SECURED FOR SHIPPING PURPOSES BY A THIN STRIP CONNECTED TO THE BACK SIDE OF THE TOP FOUR ( 4 ) DRAWERS. BY PULLING OUT THE INDIVIDUAL DRAWERS FIRMLY, IT WILL RELEASE THE THIN CLOTH STRIP IN THE BACK.