vanEssen Diver-Link Quick Reference Manual

Hide thumbs

Table of Contents

Quick Links

Download this manual

Diver-Link Preparation and Setup

Introduction

This guide outlines how to setup your remote monitoring project using Diver-HUB, Diver-Office, Diver-

Link and Divers.

The following icons are used:

Warning

Tip/suggestion

Reference to a manual

The setup consists of 11 steps:

Step 1 Create An Account ...................................................................................................................... 2

Step 2 Login ........................................................................................................................................... 2

Step 3 Create A Project .......................................................................................................................... 2

Step 4 Setup The Project ....................................................................................................................... 2

Step 5 Configure The Diver-Link Hardware ........................................................................................... 3

Step 6 Configure The Diver-Link In Diver-Hub ...................................................................................... 3

Step 7 Import Diver-Hub Project In Diver-Office ................................................................................. 3

Step 8 Program The Divers .................................................................................................................... 3

Step 9 Connect The Equipment ............................................................................................................. 4

Step 10 Activate The Diver-Link ............................................................................................................. 4

Step 11 Check The Hardware Information In Diver-Hub ...................................................................... 4

www.vanessen.com

Table of Contents

Need help?

Do you have a question about the Diver-Link and is the answer not in the manual?

Questions and answers

Summary of Contents for vanEssen Diver-Link

Page 1 Step 4 Setup the Project ........................2 Step 5 Configure the Diver-Link Hardware ................... 3 Step 6 Configure the Diver-Link in Diver-HUB ..................3 Step 7 Import Diver-HUB Project in Diver-Office ................. 3 Step 8 Program the Divers ........................3 Step 9 Connect the Equipment ......................
Page 2 Use the same name for location_name and monitoring_point_name unless you have a good reason not to, for example with nested wells. When using the Diver-Link baro logger data for barometric compensation fill in monitoring_point_name-B in the baro_for_compensation column. Always select (UTC) Coordinated Universal Time in Settings > My Profile as the time zone during import unless a time offset needs to be added.
Page 3 Diver-Link Preparation Step 5 Configure the Diver-Link Hardware Insert the SIM card, 1 or 2 batteries and desiccant in the Diver-Link and connect the external antenna (if applicable). Carefully note the polarity of the batteries: these must be inserted in parallel, facing the same direction. Polarity is indicated on the bottom of the battery holders.
Page 4 Deployment Step 9 Connect the Equipment Connect the DXT Cable and Diver to the Diver-Link and mount the Well Top Fixation. It is recommended to mount the Well Top Fixation to the cable in the office. Under these circumstances you can make sure that your Diver will be installed at the correct depth.