PRODUCT MODEL NUMBER
ELECTRICAL
115 Volt, 60 Hz., AC
A
Electrical Code and local codes and ordinances, is required.
It is recommended that a separate circuit, serving only your ice maker, be provided. Use areceptacle which cannot be
turned off by a switch or pull by chain.
WATER
A cold water supply with water pressure between
maker. If you have questions about your water pressure, call a licensed, qualified plumber.
LOCATION
To ensure proper ventilation for your ice maker, the front side must be completely unobstructed. The ice maker may be
closed-in on the top and two sides, but the installation should allow the ice maker to be pulled forward for servicing if
necessary.
Installation of the ice maker requires a cold water supply inlet of
valve or drain pump, only to carry the water to an existing drain.
Choose a well ventilated area with temperatures above
obtained between
70°F
UNIT DIMENSIONS
ICE MAKER
36.5
Full cube size 7/8"x7/8"x7/8"
Half cube 7/8" x7/8" x5/8"
SK-289S /SK-289H /SK-289U
15-
20-amp
only,
or
electrical supply, properly grounded in accordance with the National
0.13 Mpa [19
and
90°F (21°C
and 32°C).
26
Refrigerant R290
Dimensions are for planning purposes only.
psi] and
0.55 Mpa [80
3⁄8" (6.35
mm) OD soft copper tubing with a shutoff
55°F
(13°C) and below
110°F
27
E
D
W
ICE MAKER
psi] is required to operate ice
(43°C). Best results are
Need help?
Do you have a question about the SK-289S and is the answer not in the manual?
Questions and answers