Table of Contents
Advertisement
Quick Links
WATER HEATER FOR POOL & SPA
WATER HEATER FOR POOL & SPA
WATER HEATER FOR POOL & SPA
WATER HEATER FOR POOL & SPA
• The PVC tank provides sturdiness
• Contains two thermals circuit breaker and one pressure Switch
• Available power : 6 to 72 kW.
• Models are available for both interior or exterior pools and hot tubs.
ETL approved
•
25 years on PVC tank only, 2 years warranty
•
defect any manufactured defect, water-heater should be return afterwards with our
authorization without any carrying fees of transportation however, disconnection or else
won't be on Val Therm responsibility.
*Made in Canada
www.valtherm.ca | Tel : (514) 262-5010 | Fax : (450) 735-0935| info@valtherm.ca
GENERAL CHARACTERISTICS
MODÈL B
**We have no guarantee on element any time
against manufacturing all fabrication
Advertisement
Table of Contents
Summary of Contents for Val Therm B
- Page 1 • defect any manufactured defect, water-heater should be return afterwards with our authorization without any carrying fees of transportation however, disconnection or else won't be on Val Therm responsibility. **We have no guarantee on element any time *Made in Canada...
- Page 2 HOW TO DERTERMINIE THE RIGHT POWER RATING OF YOUR VAL THERM POOL HEATER The following factors will influence the power needed for your pool heater: Pool dimension, average depth, wind exposure, period of utilization, ground composition, weather, etc... With normal weather conditions as in our regions, we will be able to determine the power needed for your pool heater, based on empirical method or mathematical formulas.
- Page 3 MATHEMATICAL METHOD You can determine your heater power and also weather elevation rate for a given heater by applying this formula: • How to establish the heater power: Power (KW) = K (W/°Cft²) X temp.diff. (°C) X surfpool. (pi²) 1000 (W/KW) Conversion constant: 5.715 W/°ft²...
-
Page 4: Physical Diagram
PHYSICAL DIAGRAM 23 inches in height 20 inches 12 inches in height TITANIUM ELEMENTS OPTION FOR SALT WATER SYSTEMS... -
Page 5: Water Tank
Component List WATER TANK PVC Water tank 2-WATER INLET Female threaded socket of 1½ N.P.T. 3-WATER OUTLET Female threaded socket of 1½ N.P.T. 4-DRAINING PLUG Female threaded socket of 1 N.P.T. 5- ELECTRONIC THERMOSTAT Adjustable for Pool or Spa 6-TERMINAL BLOCK Terminal block for electricity supply 7-STATIC CONTACTOR Allow the activation of the heating elements. -
Page 6: Thermal Protection
Component List 10- BRAKER Protects the control circuit against electric overloads. (600 volts and 208 volts Water-heater only) 11-GROUND BOX Make sure that the ground box is in the ground to prevent any electrocution. 12-THERMAL PROBE When water is inferior of the temperature assign, it allows the activation of the elements though the thermostat. -
Page 7: Troubleshooting
TROUBLESHOOTING If water stays cold and pilot light is off: 1- Check the voltage 2- Check circuit breaker, main fuses and replace if necessary 3- Check the “High Temperature Cut off Switch with Manual Reset’’ (refer to the physical diagram). 4- Check thermostat. - Page 8 INSTATALLATION - LOCATION SITE This Val Therm water heater can be installed either inside or outside. We strongly recommend sheltered from rain. It is important that all safety and installation standards be respected. The water heater must be positioned vertically and at the filter end. A free space of 12’’...
- Page 9 ELECTRICITY The electrical wirings must be performed by qualified electrician.
- Page 10 PLUMBING SKETCH FOR THE WATER HEATER MODEL A OPENED OPENED VALVE VALVE Water inlet Water outlet CLOSED VALVE It is recommended to install a by-pass on the plumbing of the water heater. BY- - - - PASS PASS PASS PASS CLOSED CLOSED VALVE...
- Page 11 STAR UP Before switching on pool heater, activate the pump of the filter and ensure that no air remains inside the water heater. This can be checked when no more bubbles appear at the pool when water recycles back to the surface. Adjust the thermostat to the desired temperature level.
- Page 12 OOL HEATER WATER LIST 240 VOLTS – 1 PHASE Puissance Line current BTU/ hour # model 6 kw 25,0 A 20 427 A1P2-6 9 kw 37,5 A 30 708 A1P2-9 12 kw 50,0 A 40 944 A1P2-12 15 kw 62,5 A 51 180 A1P2-15 18 kw...
-
Page 13: Warranty
25 years on PVC tank only, 2 years warranty against manufacturing all fabrication defect any manufactured defect, water-heater should be return afterwards with our authorization without any carrying fees of transportation however, disconnection or else won't be on Val Therm responsibility. **We have no guarantee on element any time...