Table of Contents
Advertisement
Quick Links
Vertical Gas Smoker
Assembly, Use and Care
Model: SC2045604-SC-00
Tools required:
Phillips screwdriver / Adjustable wrench
This instruction manual contains important information necessary for the proper assembly and safe use of
the appliance.
Read and follow all warnings and instructions before assembling and using the appliance.
Follow all warnings and instructions when using the appliance.
Keep this manual for future reference.
Please verify that all parts are included before beginning assembly by checking the parts and hardware list. If the parts are
missing, do not attempt to assemble the appliance and call customer service at 1-888-837-1380.
SC2045604-SC-00 - ENG
For Outdoor Use Only
1 of 17
20121122-V1
Advertisement
Table of Contents
Summary of Contents for Smoke Canyon SC2045604-SC-00
- Page 1 Please verify that all parts are included before beginning assembly by checking the parts and hardware list. If the parts are missing, do not attempt to assemble the appliance and call customer service at 1-888-837-1380. SC2045604-SC-00 - ENG 1 of 17...
- Page 2 Warning: Indicates a potentially hazardous situation which, if not avoided, will result in death or serious injury. CAUTION CAUTION: Indicates a potentially hazardous situation or unsafe practice which, if not avoided, may result in minor or moderate injury. SC2045604-SC-00 - ENG 2 of 17 20121122-V1...
- Page 3 Clean and inspect the hose before each use of the appliance. If there is evidence of abrasion, wear, cuts or leaks, the hose must be replaced prior to the appliance being put into operation. 24” Keep the fuel supply hose away from any heated surface SC2045604-SC-00 - ENG 3 of 17 20121122-V1...
- Page 4 OPD safety feature-equipped tanks as described in the “LP Tank” section of this manual. Always keep new and exchanged LP tanks in upright position during use, transit or storage. Leak test new and exchanged LP tanks BEFORE connecting to appliance. SC2045604-SC-00 - ENG 4 of 17 20121122-V1...
- Page 5 Never attempt to attach this appliance to the self-contained LP gas system of a camper or trailer or motor home. The pressure regulator and hose assembly supplied with the appliance must be used. Replacement pressure regulator and hose assemblies must be those specified by the appliance manufacturer. SC2045604-SC-00 - ENG 5 of 17 20121122-V1...
- Page 6 Following al warnings and safety precautions before removing meat from the smoker or preparing the unit for storage. Follow instructions in this manual for proper storage procedures and the important warnings and safeguards. SC2045604-SC-00 - ENG 6 of 17 20121122-V1...
- Page 7 Keeping the ventilation opening(s) of the cylinder enclosed free and clear from debris. Clean all cooking surfaces of vessels, aluminum pots and pan with warm, soapy water and a nylon cleaning pad to avoid oxidation, corrosion and rusting. SC2045604-SC-00 - ENG 7 of 17 20121122-V1...
- Page 8 Burner: Wire brush loose corrosion from burner exterior. Clean clogged gas port holes with an opened paper clip. Replace corroded or damaged burners that would emit excess gas. Cooking surfaces, pots and pans: Clean the cooking surface with soapy water and a nylon cleaning pad. Product Diagram SC2045604-SC-00 - ENG 8 of 17 20121122-V1...
-
Page 9: Parts List
Hook Regulator Hook Qty: 1pc Qty: 1pc Qty: 1pc Regulator Hook Regulator Hook 1 pc 1 pc Regulator Hook 1 pc 1 pc 16- Regulator Hook 1 pc tor Hook Qty: 1pc SC2045604-SC-00 - ENG 9 of 17 20121122-V1... -
Page 10: Hardware List
Hardware List ROUND BOLT 29 pcs M6x12 13 pcs NUT M6 FLANGE LOCK 1 pc 1 pc CAP NUT SPRING WASHER 1 pc METAL WASHER 4 pcs FIBER WASHER 1 pc SPRING SC2045604-SC-00 - ENG 10 of 17 20121122-V1... - Page 11 (see detail A) Attach the igniter wire to the igniter on the control panel (10). (see detail B) Detail A Wire Venturi Valve Detail B SC2045604-SC-00 - ENG 11 of 17 20121122-V1...
- Page 12 Install the TEMPERATURE GAUGE (7) through the door and secure using the supplied nut, This nut is pre-assembled on the temperature gauge. Assemble the SMOKE STACK (11) as shown using 4 sets M6 x 12 bolts (A) and M6 nuts (B) SC2045604-SC-00 - ENG 12 of 17 20121122-V1...
- Page 13 Set the WOOD CHIP TRAY (6) support in the bottom of the smoker as shown. Set WATER TRAY (6) in the second position of the smoker as shown. Insert the COOKING GRID (4) into any of the remaining positions as desired. SC2045604-SC-00 - ENG 13 of 17 20121122-V1...
- Page 14 Opening the smoke stack cover helps to exhaust both the heat and smoke. The key to effective smoking is to watch your heat indicator on the door and adjust the dampers accordingly. Temperature is best controlled by different damper adjustment configurations. SC2045604-SC-00 - ENG 14 of 17 20121122-V1...
-
Page 15: Troubleshooting
“LOW” Smoker is not Pre-heat smoker sufficiently sufficiently pre-heated Grill is too Excess grease build-up Clean smoker components thoroughly causing grease fires Cook on a lower Lower flame height and temperature temperature setting SC2045604-SC-00 - ENG 15 of 17 20121122-V1... -
Page 16: Limited Warranty
2. All parts to be replaced will need to be shipped before replacement items will be sent. 3. Follow the Customer Service Representative’s instructions exactly. If a return is necessary, it must be packed carefully and shipped prepaid. SC2045604-SC-00 - ENG 16 of 17 20121122-V1... -
Page 17: Obtaining Replacement Parts
WE CAN HELP. Rankam Metal Products Manufactory Ltd. 1618 W. Rosecrans Ave., Gardena, CA90249 Please contact Rankam Customer Service at customerservice@rankam.com or at 1-888-837-1380, Mon to Fri, 8:00 a.m. – 5:00 p.m. Pacific Standard Time SC2045604-SC-00 - ENG 17 of 17 20121122-V1...
Need help?
Do you have a question about the SC2045604-SC-00 and is the answer not in the manual?
Questions and answers