Related Manuals for Nordisk RAT BLOCKER TX11
Summary of Contents for Nordisk RAT BLOCKER TX11
- Page 1 R AT B LO C K ER T X11 ® - INSTALLATION MANUAL Applies to rat blocker TX11 with gate moun- ted with thumbscrew. N.B. Before mounting, always check that the thumbscrew is tightened...
- Page 2 ORIENTATION OF THE GATE The rat blockers from Nordisk Innovation Positioning the gates incorrectly will lead are made with a reversible gate, so that the to a blockage of the flow as the gates are blockers can be mounted on both the inlet prevented from opening.
- Page 3 INSTALLATION INSTRUCTIONS Remove the cover and inspect the Then turn the mounting pipe well, and clean as necessary. clockwise until desired tension is achieved. Removed the alignment Fitting tubes are assembled to the tube, and the installation is ready desired length, and are fitted on the for a test flush.
- Page 4 NOTE! Important information To prevent tearing and burning of the thread, the threaded piece on the rat block- ers from Nordisk Innovation is made of acid-resistant stainless steel, which has subsequently been coated with a layer of hard chromium plating.