Summary of Contents for AIRLIFT AL-MV10B
- Page 1 ULTRA COOL VENTILATION MASK User Manual Please read this guide thoroughly before operating and keep it handy for reference at all times...
-
Page 2: Table Of Contents
Thank you for purchasing this AIRLIFT product. Before operating your new appliance, please read these instructions carefully. This user manual contains information for safe use, installation and maintenance of the appliance. Please keep this user manual in a safe place for future reference. This will ensure safe use and reduce the risk of injury. -
Page 3: Explanation Of Symbols
Explanation of Symbols Please make sure to read the following safety precautions as they are designed to prevent unexpected danger and damage. These safety precautions are divided into two sections, Warning statements and Caution statements. WARNING CAUTION Indicates a potentially hazardous situation which, Indicates a potentially hazardous situation which, if not avoided, could result in death or serious if not avoided, may result in minor or moderate... -
Page 4: Important Safety Instructions
Important Safety Instructions WARNING Failure to follow the instructions laid down in this manual may cause serious injury or death. • It is important that you follow the instruction as mentioned in this manual. • This mask is not a medical device nor is it personal protective equipment. •... -
Page 5: Before Use
• Adjustable Lanyard x1 • Quick Start Guide x1 Parts and Specification Product Name: AirLift Ventilation Mask Model: AL - MV10B Input Power: USB DC 5V 1A Operation Temperature: 10 – 40 °C Power Bank Capacity: 2500mAh Mask and Filter Type: Disposable Mask and Filter... -
Page 6: Installation And Operations
Installation and Operation NEW INSTALLATION 1. Take out the new filter from the packaging 2. Release the Filter Retainer from the Filter Cap 3. Place the new filter between Filter Cap and Filter Retainer and press fit the retainer with the Filter Cap tightly (see. -
Page 7: Replacing Used Mask
Installation and Operation REPLACING USED MASK AND FILTER 1. Ensure the power of AIRLIFT mask is turned off when replacing new mask (see. Pic F5) 2. Disconnect the cable from the Ultra Cool Ventilator and uninstall the ventilator in the used mask (see. -
Page 8: Cleaning And Maintenance
Cleaning and Maintenance Ultra Cool Ventilator: • Turn off the ventilator before cleaning; make sure no power supply is connected • Wipe the surface with a soft, damp cloth or a wet paper towel. Note: - Stains from some cosmetics may be difficult or impossible to remove even if the ventilator is cleaned immediately after use. - Do not allow water to get inside the product. - Page 9 Symptoms Symptoms Suggested Solution Suggested Solution The battery is discharged or needs to be replaced. The appliance does not operate. The ambient temperature is too high or too low. Check the ambient temperature. The Filter Cap may be colgged or installed improperly. Fan is noisy even on the lowest speed.
- Page 10 30/F, Tower 1 of Enterprise Square 5, 38 Wang Chiu Road, Kowloon Bay, Kln, HK Email: inquiry@ingenio-tech.com ©2022 INGENIO TECHNOLOGY CO LTD and AirLift Logo are trademarks licensed for use by INGENIO TECHNOLOGY CO LTD. and registered in H.K. www.airliftmask.com...
Need help?
Do you have a question about the AL-MV10B and is the answer not in the manual?
Questions and answers