Table of Contents
Advertisement
Cleaning the self-cleaning surfaces in the cooking
compartment
The back wall in the cooking compartment is coated with a
highly porous ceramic layer. This coating absorbs and
disintegrates splashes from baking and roasting while the oven
is in operation. The higher the temperature and the longer the
oven is in operation, the better the result will be.
If splashes are still visible even after repeated use, proceed as
follows:
Clean the floor, ceiling and side panels of the cooking
1.
compartment thoroughly.
Set
3D hot air.
:
2.
With the door closed, heat up the empty oven for
3.
approximately 2 hours at maximum temperature.
The ceramic coating is regenerated. When the cooking
compartment has cooled down, remove the brown or white
residue with water and a soft sponge.
Light discolouration of the coating does not affect automatic
self-cleaning.
Caution!
Never use abrasive cleaning agents. You will scratch or
■
destroy the highly porous coating.
Never treat the ceramic coating with oven cleaner. If oven
■
cleaner accidentally gets onto it, remove it immediately with a
sponge and plenty of water.
Detaching and refitting the rails
The rails can be removed for cleaning. The oven must have
cooled down.
Unhooking the rails
Hold the shelf frames from underneath and pull slightly
1.
forward. Pull the extension pins at the bottom of the rails out
of the mounting holes (Fig. A).
Then fold the rails upwards and carefully remove them
2.
(Fig. B).
Clean the rails with washing-up liquid and a sponge. For
stubborn deposits of dirt, use a brush.
Installing the frames
Insert the two hooks carefully into the upper holes. (Figure A-
1.
B)
20
:
Incorrect assembly!
Never move the frame before the two hooks are fully
anchored in the upper holes. The enamel could be damaged
and may break (figure C).
the two hooks must be inserted fully into the upper holes.
2.
Now move the frame slowly and carefully downwards and
insert in the lower holes (figure D).
Insert both frames into the side walls of the oven (figure E).
3.
If the rails are fitted correctly, the distance between the two
upper shelf positions is greater.
Detaching and attaching the oven door
For cleaning purposes and to remove the door panels, you can
detach the oven door.
The oven door hinges each have a locking lever. When the
locking levers are closed (figure A), the oven door is secured in
place. It cannot be detached. When the locking levers are open
in order to detach the oven door (Fig. B), the hinges are locked.
They cannot snap shut.
:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. Ensure that the locking levers are always fully closed or,
when detaching the oven door, fully open.
Advertisement
Table of Contents
