Contents Chapter 1: Getting to Know Your Menopod® Menopod® Overview Accessories How It Works Chapter 2: Getting Started Charge Your Menopod® Understanding the LED Indicators Chapter 3: How to Use Your Menopod® Warnings Instructions For Using Your Menopod® Troubleshooting Appendix A: Safety, Handling & Support...
Getting to Know Your Menopod® Menopod® Overview This guide describes the features of your Menopod®. LED INDICATORS POWER SWITCH MICRO-B USB CONNECTOR COPPER PLATE Accessories...
Page 4
Use the Micro-B USB cable to connect any your Menopod® to any USB power source and charge the battery. USB Power Adapter Use the USB power adapter to connect your Menopod® to a power outlet and charge your Menopod® battery.
Before using your Menopod®, make sure that the battery is fully charged. Connect your Menopod® to a USB Power Adapter or USB port using the included Charging Cable, and allow the Menopod® to charge until all four (4) LED indicator lights are solid green. Understanding The LED Indicators The LED Indicators display the status of your Menopod when it is in use or charging.
Page 7
See Troubleshooting for more details. • • • • Blinking while operating: Overheated. Allow up to ten (10) minutes for Menopod® to cool. • • • • No lights when switch is slid sideways: Battery depleted. Unit must be recharged No lights when charging: No power.
How to Use Your Menopod® Warnings Do not leave your Menopod® in your car on a hot or cold day. Excessive heat or cold may cause damage to the operation of the device. The copper plate can become very hot if left in the heat.
Page 9
Slide the power button to the left of to turn the Menopod® on. Your Menopod® will cool to 5 C (41 F) within four (4) seconds.
Page 10
Place the Menopod® on the back of your neck for instant cooling relief. Slide the Menopod® from side to side on the back of your neck every ten (10) seconds.
Page 11
Once the cycle is completed, the Menopod can be run for another cycle immediately as needed. Please be aware that the Menopod can only run a few cycles in rapid succession before overheating. Please wait ten (10) minutes for the Menopod® to cool before using again.
Try another USB Power Adapter if available. • If no other USB Power Adapter is available, connect your Menopod® to a powered USB port. If the USB port is on a computer, the computer must be turned on and not in sleep mode.
Menopod® can be damaged if dropped, burned, punctured, crushed, or if it comes into contact with liquid. Do not use a damaged Menopod®, such as one with a cracked case, as it may cause injury. Repairing: Do not open Menopod® and do not attempt to repair Menopod®...
When you use the USB Power Adapter to charge Menopod®, make sure that the Charging Cable is fully inserted into the adapter before you plug it into a power outlet.
Page 15
F). Menopod® can be damaged and its battery life shortened if stored or operated outside of these temperature ranges. Avoid exposing Menopod® to dramatic changes in temperature or humidity. When you are using Menopod® or charging the battery, it is normal for...
Menopod® to get warm. If the interior temperature exceeds normal operating temperatures (for example, in a hot car or in direct sunlight for extended periods of time), you may experience the following as it attempts to regulate its temperature: •...
Page 17
WARRANTIES CANNOT BE DISCLAIMED, HUMANTEC INC. LIMITS THE DURATION AND REMEDIES OF SUCH WARRANTIES TO THE DURATION OF THIS EXPRESS WARRANTY AND, AT HUMANTEC INC. ’ S OPTION, THE REPAIR OR REPLACEMENT SERVICES DESCRIBED BELOW. SOME STATES (COUNTRIES AND PROVINCES)
Need help?
Do you have a question about the Menopod and is the answer not in the manual?
Questions and answers