Summary of Contents for North States Industries Pet Gate 5
Page 1
Parts: Important: Please remove all parts from the carton and review the parts diagram to familiarize yourself with the Pet Gate 5 and all components before you install the gate. Parts List: Part no.
Page 2
Once decided, you are ready to begin with the installation of the wall hinge (this is the side that does not swing out). If you have hard flooring, (tile, ceramic, etc.) the bottom "foot" of the wall hinge should be placed on the flooring. (Figure 2) If your flooring is carpeted, the bottom of the foot should be even with the top of your carpeting.
Page 3
If your Pet Gate does not swing in the desired direction, it can be removed from the wall hinge (until the locking clip is installed, the gate has no top or bottom) rotated 180 degrees, and remounted. To remove the gate from the wall hinge, press in on the upper locking boss (Figure 6) located on the wall hinge, and lift up on the gate itself, until the gate rib clears the locking boss.
Page 4
To unlock the gate, push down with your thumb on the locking clip, and pull up on the gate panel. (Figure 10) You can remove the gate, as described in the installation instructions, for cleaning. The gate can be cleaned with a mild household detergent. Warning: To prevent serious injury or death, securely install gate and use according to manufacturer's instructions.