sugar-valley NetBus RS2NET User Manual

Ethernet module

Advertisement

USER GUIDE ETHERNET MODULE (REF. RS2NET)
Technical manual V1.0
NetBus is a module produced by Sugar Valley in order to allow the interconnection between a Sugar Valley device
and the VistaPool system.
Likewise, the NetBus module allows the work with the PoolShow system of Sugar Valley to see the pool
parameters.
IMPORTANT: The NETBUS module and the PoolShow system must to be in the same network local to work
properly.
This module allows an internet wired connection, replacing the WIFI solution
IMPORTANT: The
manual
operating ways of the devices, like the information used to generate
recommended
to keep this document only for the internal use of Sugar Valley.
NETBUS module

Starting the system:

When the NetBus box is opened, you will find the folloging parts:
- NETBUS module
- MODBUS RTU wire connection
- Ethernet wire
The device can power from an 12V external adapter, or from the device. To install, complete the following steps:
contains
instructions
Local internet Network
Pool controller
1
for
the
acces
to
a
a
ADSL modem
Internet
Vistappol web server
low
level of differents
firmware
upgrade
file. It's
EN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NetBus RS2NET and is the answer not in the manual?

Questions and answers

Summary of Contents for sugar-valley NetBus RS2NET

  • Page 1 USER GUIDE ETHERNET MODULE (REF. RS2NET) Technical manual V1.0 NetBus is a module produced by Sugar Valley in order to allow the interconnection between a Sugar Valley device and the VistaPool system. Likewise, the NetBus module allows the work with the PoolShow system of Sugar Valley to see the pool parameters.
  • Page 2 1. Connect the NETBUS module as follows: Power 9Va 27V RS485 MODBUS RTU Ethernet 10/100 Button The Ethernet port must be connected to the router/switch you have available. The RS485 MODBUS RTU port must be connected to the connector labeled as WIFI in the Sugar Valley device. 2.
  • Page 3 Indicator Blinking The device is off and it's not There is POWER on the device. working. Check the power Power Serching device on MODBUS MODBUS The search of the equipment System found and has not sterted network. Wait 1 - 2 minutes identified connection The internet...

Table of Contents