Summary of Contents for DCA AQW5.5/10
- Page 1 Read through carefully and understand these instructions before use. Edition 2 Aug., 2019...
-
Page 2: General Power Tool Safety Warnings
operation. GENERAL POWER TOOL SAFETY WARNINGS e) Cleaning Agent The appliance has been designed for use with the cleaning agent supplied or Please read and comply with these original instructions prior to the initial operation. Danger! recommended by the manufacturer. The high pressure produced by the appliance is very hazardous if f) Checking the Appliance Before Operation connected with power source. -
Page 3: General Descriptions
The water jet that is emitted from the high pressure nozzle results in a repulsion GENERAL DESCRIPTIONS power acting on the hand spray gun. Make sure that you have a firm footing and are also holding the hand spray gun and spray lance firmly. ... -
Page 4: Specifications
2) Place pressure pipe hook in correct position SPECIFICATIONS according to drawing and fix it onto the body with two pieces of 3.5 X20 cross screw stud. Rated Flow 5.5 L/min (Fig. 2) 0~40 ℃ Rated Temperature Rated Power Input 1600 W Max. -
Page 5: Water Connection
bottom. (Fig. 5) 3) Turn off water supply, connect water intake to water inlet nut with quick connector •Connect to the water supply with lower pressure The machine can also operate in self-suction mode, which means the machine can be connected to water containers, rivers, lakes and pools, no backflow preventer is needed when diverse from non-portable water mains. -
Page 6: Stop The Pressure Washer
1) Insert power plug into the power socket. 1) Cut off water supply, activate the trigger of (Fig. 9) pikestaff, and keep the machine running until water no longer flows from the nozzle. 2) Stop the machine and press the switch to OFF position. -
Page 7: Troubleshooting
Machine starts, Pump/pipes or accessory Wait for pump/pipes or accessory to After Using Pressure Washer but no water frozen thaw. comes out No water supply Connect inlet water. Water filter blocked Clean the filter /Clean the nozzle It should be kept in frost-free room. It is necessary to check the machine for damage if /Nozzle blocked it is frozen by mistake. - Page 8 Cleaning the Machine Ventilation Opening The machine should be kept clean so that cold air can go through ventilation opening freely. (Fig. 19) Lubrication of O ring In order to ensure easy connection and make the O ring not dry out, various types of joints should be lubricated periodically.
- Page 9 EXPLANATION OF GENERAL VIEW EXPLANATION OF GENERAL VIEW Front Cover Assembly Wheel Assembly Inlet Helicoil Air Deflector Cap Decorative Plate Wheel Cover Outlet Helicoil Hose (Inside) Front Cover Wheel End Cap Pan Head Tapping Screw Switch Knob Wheel Plate (Left) Nozzle Cleaner (Flat Head) Motor Fixing Plate (Rear) Decorative Plate...
Need help?
Do you have a question about the AQW5.5/10 and is the answer not in the manual?
Questions and answers