1. Manuals
  2. Brands
  3. DCA Manuals
  4. Drill
  5. Z1J-FF03-13
  6. Operation instructions manual

DCA Z1J-FF03-13 Operation Instructions Manual

Electric impact drill
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

Read through carefully and understand these instructions
before use.
Edition 1 Mar., 2012

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Z1J-FF03-13 and is the answer not in the manual?

Questions and answers

Summary of Contents for DCA Z1J-FF03-13

  • Page 1 Read through carefully and understand these instructions before use. Edition 1 Mar., 2012...

  • Page 2: Electrical Safety

    outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric GENERAL POWER TOOL SAFETY WARNINGS shock. 9. If operating a power in a damp location is unavoidable, use a residual current (For All Power Tools) device (RCD) protected supply.

  • Page 3: Specifications

    application. The correct power tool will do the job better and safer at the rate SPECIFICATIONS for which it was designed. 18. Do not use tool if switch does not turn it on or off. Any power tool that Rated Power Input 500 W cannot be controlled with the switch is dangerous and must be repaired.

  • Page 4: Instructions For Operation

    A speed adjusting dial is provided so that maximum tool speed can be limited INSTRUCTIONS FOR OPERATION (variable). Turn the speed adjusting dial in “+” direction for higher speed, and in “-” direction for lower speed. Installing or Removing Drill Bit Reversing the Rotational Direction CAUTION: Always be sure that the tool is switched...

  • Page 5: Installing Auxiliary Handle

    excessive pressure will only serve to damage the tip of your bit, decrease the Installing Auxiliary Handle tool performance and shorten the service life of the tool.  There is a tremendous force exerted on the tool/bit at the time of hole break Always use the auxiliary handle ensure operating safety.
  • Page 6 Remove the handle cover by loosening the screws on it with a screwdriver, and remove the holder plate. Pull out the brush holder and disconnect the wire connecting to the stator, then remove the worn out carbon brushes and replace new ones.
  • Page 7 EXPLANATION OF GENERAL VIEW Cross Recessed Countersunk Chuck Key Head Screw M4×10 Drill Chuck Armature Assembly Spindle Baffle Plate Cross Recessed Head Circlip for Hole Tapping Screw ST4.2×55 Dust Seal Stator Assembly Ball Bearing 6002DU Ball Bearing 608ZZ Ratchet 2 Rubber Pin Ratchet 1 Motor Housing...

Table of Contents