The “ ” control unit is a device suitable for moving electrical shutters, curtains or overhead doors ROLL SHUTTER SW and it's part of devices for home & building automation. It can be easily installed thanks to its reduced dimensions and simple wiring required.
Registration is confirmed by the keyfob with a series of 4 green blinks. If the keyfob was previously registered to another Smart Sw, it's necessary to erase the previous registration, before attempting a new registration. N.B. If when pushing the button it immediately emits a single yellow blink, it means that the button was already registered and to be registered again, the previous registration need to be erased.
Page 4
Keyfob commands The shutter can be governed by two buttons, one to lift and one to lower (with parameter “COMMAND TYPE”=2) or with just one button in “step” or “sequential ” mode (with parameter “COMMAND TYPE”=1). Warning: change “COMMAND TYPE”, imply the generation of a new digital security key so the impossibility to command the switch with previous registered keyfobs which would need a new registration.
Shell protection IP65 Battery type CR2032 Battery life * > 5 years Radio range 20 / 50 m -10 — +50°C Operating temperature * life get calculated for 10 commands per day WARRANTY The warranty period of 2 years start on day of purchase. Warranty doesn't cover damages caused by: - wrong installation, - failure to observe these instructions,...
Page 6
3- Push the ”Start NFC Connection” button, under the “Loren Controls” logo. 4- Like asked by message on the screen, place the phone on top of the Smart Sw enclosure where the NFC symbol is. 5- If the connection is activated, another screen will appear, showing Software/Hardware data and 2 buttons.
Page 7
Start NFC Connection > Set UP MENU Start NFC Connection >SET UP MENU Start NFC Connection >SET UP MENU > Parameter setting > Change Password > Radio setting Start NFC Connection >SET UP MENU > Security setting...