Advertisement
Skylark FPV
Skylark FPV 433 UHF Long Range
1. Specification
A. Transmitter voltage：10V-16.8V Current: <500mA
B. Receiver voltage:4V-8.4V Current:<50mA
2. RC Transmitter
Please always mount the antenna before power on the device
on
Transmitter LED:
LED2
Solid
Off
Quick Blink
User Manual
Status
The receiver cannot detect any
PPM signal, please check the
PPM cable.
Normal mode
Binding mode
http://www.SkylarkFPV.com
Advertisement
Table of Contents
Summary of Contents for Skylark FPV
- Page 1 Skylark FPV http://www.SkylarkFPV.com Skylark FPV 433 UHF Long Range User Manual 1. Specification A. Transmitter voltage：10V-16.8V Current: <500mA B. Receiver voltage:4V-8.4V Current:<50mA 2. RC Transmitter Please always mount the antenna before power on the device Transmitter LED: LED2 Status Solid...
- Page 2 Skylark FPV http://www.SkylarkFPV.com Transmitter buzzer Buzzer Status Beep Fail safe setting Keep beep System exception 3. RC receiver LED Indication Status Receiving signals Slow Blink No signal reception Quick Blink Binding mode Solid Failsafe mode 4. Binding Press transmitter [SET]...
- Page 3 Skylark FPV http://www.SkylarkFPV.com 5. Failsafe setting Turn on the transmitter, Keep the remote control in failsafe position Press transmitter [SET] button 3 seconds, Wait for the transmitter's voice of beep, it will send the failsafe data If the receiver get the data, its LED will blink several times, the setting finish...
- Page 4 All the trademarks, pictures, and brands mentioned in this document are the property of Skylark FPV Technologies Co., Ltd. or their respective holders. Copyright ©2014 Skylark FPV Technologies Co., Ltd. All rights reserved.
Need help?
Do you have a question about the FPV and is the answer not in the manual?
Questions and answers