DATASHEET
Manufacturer:
Hatteland Technology AS
External Remote Controller for Monitors
Product:
Typenumber:
HD REM SX1-A1
External Remote Controller for Monitors
Description:
The remote controller enables the control of Series 1 G2, Series X G1, Series X G2, MVD Series and selected HM CMD / RMD monitors
by providing instant keypad functionality over RS-485/422 bus through the well implemented SCOM Protocol by Hatteland Technology
AS. A single press on the remote controller will trigger the same physical press on all connected/configured units with the
synchronized reaction of corresponding button presses. The remote controller provides several functions through 3 physical buttons
for user interaction. Remote Control is powered and driven by first monitor unit (which has to be connected to external power cable/
source. It is not required to turn the monitor unit on for the Remote Control to control/operate other monitor units that may be in
the same chain).
Specifications:
• Connector
1 x 6-pin Terminal Block 3.81, non-isolated
• Mounting
Includes mounting bracket with 2 x PanHead M3x6mm.
(Tightening Torque 0.8 Nm) and 2 x Thumb Fastening screws for console
mounting.
• Physical Dimensions
W:125.00 [4.92"] x H:37.50 [1.48"] x D:72.30 [2.83"] mm [inch]
• Weight
123g
• Connectivity
- Shipped with 1 x 6-pin Terminal Block 3.81 loose connector (Art: 1828388)
- Connect Remote Control to first display unit, other units in connection chain
will receive same commands.
- See page 2 for Physical Wire Connections.
• User Manual
- This datasheet. Detailed usage: SCOM Technical Manual can be used with
command-set regarding User Controls:
Series 1 G2 models:
https://www.hattelandtechnology.com/hubfs/pdfget/inb100018-12.htm
Series X G1 models:
https://www.hattelandtechnology.com/hubfs/pdfget/inb100018-4.htm
Series X G2 models:
https://www.hattelandtechnology.com/hubfs/pdfget/inb100018-6.htm
Multi Vision Display MVD models:
https://www.hattelandtechnology.com/hubfs/pdfget/inb100018-8.htm
• Test and certificate
Hatteland Technology standard, (tested / type approved by the
following classification societies):
IEC 60945 4th (EN 60945:2002), IACS E10,
EU RO MR - Mutual Recognition, ClassNK - Nippon Kaiji Kyokai
FRONT VIEW
TOP VIEW (w/ console panel)
Dimensions might be shown with or without decimals and indicated as mm [inches]. Tolerance on drawings is +/- 1mm. For accurate measurements, check relevant DWG fi le.
Hatteland Technology AS | www.hattelandtechnology.com | Enterprise no: NO974533146
This information may not, in whole or in part, be copied, photocopied,
reproduced, translated or reduced to any electronic medium or machine-
readable form without the prior written consent of Hatteland Technology
AS. The products may not be copied or duplicated in any way.
BACK VIEW
PANEL CUTOUT
Last Revised:
Revision#:
1 2 3 4 5 6
ACCESSORY
16 Sep 2022
21
SIDE VIEW
1/6
1/2