Advertisement
Table of Contents
- 1 Step 1: Connect the Winch Plug into the Winch/Control Box Plug.
- 2 Step 2: Plug the Battery into the Power Connection Wire.
- 3 Step 3: Flip the Switch on the Back to Turn It On.
- 4 Step 4: Use Phillips Screwdriver to Remove the Screws.
- 5 Step 6: Wiggle the Circuit Board Back and Forth.
- 6 Step 7: Reinstall the Rear Case and Install the Two Screws.
- 7 Step 8: Install the Battery by Pushing It into the Circuit Board.
- Download this manual
Step 1.
Plug the battery into the power connection wire.
Step 3.
Flip the switch on the back to turn it on.
Install lanyard here.
Wireless Warn Winch
Instruction Manual
Step 2.
Push and hold the bind button on the wireless control
box while plugging in the battery connection.
Step 4.
Push and hold both buttons on the TX to allow binding
to take place.
1
Step 5.
Connect the winch plug into the winch/control box
plug.
Step 7.
Check operation of the winch.
100-0114
Wireless Warn Winch
Instruction Manual
Step 6.
Plug the winch control box plugs into the control box
marked W+/W-. Check for proper insertion, with the
red plug going to (+) and the black plug to (-).
2
100-0114
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for RC4WD Z-E0130
- Page 1 Wireless Warn Winch Wireless Warn Winch Instruction Manual Instruction Manual Step 1. Step 2. Step 5. Step 6. Connect the winch plug into the winch/control box Plug the winch control box plugs into the control box Plug the battery into the power connection wire. Push and hold the bind button on the wireless control plug.
- Page 2 Wireless Warn Winch Wireless Warn Winch Instruction Manual Instruction Manual Step 1. Step 2. Step 5. Step 6. Use Phillips screwdriver to remove the screws. Remove the case back. To install a new battery, pull the currently installed When installing the new batteries, make sure they battery out.
Need help?
Do you have a question about the Z-E0130 and is the answer not in the manual?
Questions and answers