4-conductor, shielded, polyurethane jacket cable with 4-socket m12 connector with triax pinouts on one end and triple splice of three bnc plugs nf on the other end (6 pages)
High temp armor jacket fep cable, 2-conductor, twisted pair w/drain, shielded with a rightangle high temperature (+356 f) pps conn. with stainless steel ollar and fkm heat shrink strain relief on one end and a blunt cut termination on the other end (6 pages)
Polyurethane cable, 2-conductor twisted pair w/drain, shielded with 2-socket, molded composite connector on one end and bnc plug on the other end with red heat shrink (1") overlapped by blue heat shrink (1/2”) on both ends. configurable length (6 pages)
Polyurethane cable, 2-conductor twisted pair w/drain, shielded with 2-socket, molded composite connector on one end and bnc plug on the other end) with green heat shrink (1") overlapped by blue heat shrink (1/2”) on both ends. configurable length (6 pages)
Polyurethane cable, 2-conductor twisted pair w/drain, shielded with 2-socket, molded composite connector on one end and bnc plug on the other end) with yellow heat shrink (1") applied to both ends. configurable length (6 pages)
Polyurethane cable, 2-conductor twisted pair w/drain, shielded with 2-socket, molded composite connector on one end and bnc plug on the other end) with blue heat shrink (1") applied to both ends. configurable length (6 pages)
Summary of Contents for PCB Piezotronics IMI SENSORS 009M205/100
Page 1
Model 009M205/100 N-male to N-male 400 series low loss antenna cable- 100-ft Installation and Operating Manual For assistance with the operation of this product, contact the PCB Piezotronics, Inc. Toll-free: 800-959-4464 24-hour SensorLine: 716-684-0001 Fax: 716-684-3823 E-mail: imi@pcb.com Web: www.imi-sensors.com...
Page 2
Assistance is needed to safely operate equipment PCB Piezotronics is an ISO-9001 certified company whose Damage is visible or suspected calibration services are accredited by A2LA to ISO/IEC Equipment fails or malfunctions 17025, with full traceability to SI through N.I.S.T.
Page 3
CAUTION Refers to hazards that could damage the instrument. NOTE Indicates tips, recommendations and important information. The notes simplify processes and contain additional information on particular operating steps. The following symbols may be found on the equipment described in this manual: This symbol on the unit indicates that high voltage may be present.
Page 5
Component Name Hazardous Substances Lead (Pb) Mercury (Hg) Cadmium (Cd) Chromium VI Polybrominated Polybrominated Compounds Biphenyls (PBB) Diphenyl Ethers (Cr(VI)) (PBDE) Housing PCB Board Electrical Connectors Piezoelectric Crystals Epoxy Teflon Electronics Thick Film Substrate Wires Cables Plastic Solder Copper Alloy/Brass This table is prepared in accordance with the provisions of SJ/T 11364.
Page 6
Model Number Revision: A LOW LOSS ANTENNA CABLE 009M 205 ECN #: 50297 OPTION AL VERSION S Performance EN GLISH Optional versions have identical specifications and accessories as listed for the standard model except Number of Conductors where noted below. More than one option may be used. Cable Style Coaxial Coaxial...
Need help?
Do you have a question about the IMI SENSORS 009M205/100 and is the answer not in the manual?
Questions and answers