Larson Electronics ALU-TP-158 Instruction Manual

Industrial Aluminum Tripod - Extends from 3.5 to 10 feet
TRIPOD ASSEMBLY
The tripod assembly consists of 3 parts:
1. T-bracket
2. Extension Pole
3. Leg Base
To assemble quadpod:
1. Begin by placing the legs in a flat level area.
2. Extend the legs to hold up the tripod.
3. Loosen legs and slide down until fully deployed. Tighten hand screw.
4. Finally, attach T-bracket over the top Extension Pole and tighten hand
screw.
Use appropriate measures to attach equipment to the top of T-bracket. Predrill holes through top and
bottom and utilize bolts for mounting heavy equipment.
WARNING: Use caution before tilting tripod with a heavy load. For heavy loads, it is recommended
to remove the T-bracket prior to transporting! Failure to do so may cause serious injury. Larson
Electronics shall not be held liable for injuries caused by misuse.
1. Place tower in desired location that is flat and able to support the tripod without falling over.
2. Loosen hand screw and lower legs until firmly stabilizing tripod.
3. Tighten hand screw to secure legs.
4. With help, place the T-bracket over top pole and tighten hand screw.
Light weight devices can be attached by tilting tripod toward the ground with the legs up. Attach T-
bracket to pole, tighten hand screw and tilt back to its vertical position. DO NOT tilt tripod while
extended to max height. It is recommended to have another person hold the tripod while tilting
vertically.
For heavy equipment, use a ladder and extra help for attaching T-bracket to pole.
Double check that all hand screws are tight before continuing use of the tripod tower.
Larson Electronics, LLC
Instruction Manual
Phone: (800) 369-6671 Fax: (903) 498-3364
ALU-TP-158
www.larsonelectronics.com 1 of 2