Do you have a question about the BIOMOOV and is the answer not in the manual?
Questions and answers
Summary of Contents for Mazet Sante BIOMOOV
Page 1
Page 1 on 20 DATE 13/04/2022 A0 version BIOMOOV Manual Proprioception sensor...
Page 2
Page 2 on 20 DATE 13/04/2022 A0 version Instructions for use & Technical description Please read these instructions carefully before using your new device! This manual is an integral part of the device and must be kept until it is destroyed. This equipment has been designed and manufactured for use in a therapeutic setting.
Equipped with a software, the BioMoov allows, through a Bluetooth connection to the Biostim, to transcribe the patient's activities on a proprioception board. The BioMoov is provided in a pouch, with a USB cord to recharge it, and a scratch to fix it on a proprioception tray.
DATE 13/04/2022 A0 version Description and technical information -This user and maintenance manual is published to facilitate the handling of your BioMoov from the initial reception phase, then the commissioning to the successive stages of use and maintenance. If you have any difficulty in understanding this manual, contact the manufacturer, Électronique du Mazet, your dealer or distributor.
Page 6 on 20 DATE 13/04/2022 A0 version 2.1 Symbols used Warning: this logo draws your attention to a specific point Operating Instructions: This logo informs you that the operating instructions must be read for safe use of the device Recycling: This device should be disposed of at an appropriate collection and recycling facility.
Scratch Accessories are for personal use only. The BioMoov is not in contact with the patient. Indeed, it is intended to be fixed only on a proprioception tray. The use of accessories not recommended by the manufacturer does not engage his responsibility 2.3 Identification label...
Page 9 on 20 DATE 13/04/2022 A0 version Warnings CAUTION: Install the unit on a flat, stable surface . Do not block the rear ventilation openings (no objects closer than 4 cm). CAUTION: The appliance must be plugged into an outlet with a grounding terminal (Class I electrical appliance).
Installation of the device Open the package, remove the accessories and the BioMoov device. Check the contents against the packing list included with the documentation. Check that the contents of the box are not damaged; if you have any doubts about the integrity of the device or its accessories and that the proper functioning of the device could be questioned, contact Électronique du Mazet...
Turn on the device with the on/off button located on the device. The BioMoov turns on and a LED flashes. 6.1.2 Use of Bluetooth See setting specification. 6.1.3 Warning screen When the BioMoov device is connected to the Biostim, a logo is displayed on the Biostim screen.
Page 12 on 20 DATE 13/04/2022 A0 version 6.2 Choice of treatment Refer to the Biostim user manual. 6.3 Setting the parameters Turn on the device and click on the Bluetooth logo (under the house). When the accessory is connected, the Bluetooth logo turns green, and the logo of the connected accessory appears on the right with a bar graph indicating the available battery level The accessory is then used like the other probes, by choosing the channel to be used that corresponds to the probe in the BFB menu.
Page 13 on 20 DATE 13/04/2022 A0 version 6.4 Run a treatment 6.4.1 Start the treatment Use the BioFeedBack exercise module. Reminder: Taring Biofeedback The taring works automatically. However, it is possible to adjust the parameters calculated by the machine with the buttons Procedure for taring •...
Page 14 on 20 DATE 13/04/2022 A0 version • Zero Biostim : minimum measurable by the device : to work in negative BFB • It is also possible to choose intermediate values: 6.4.2 During treatment All parameters can be changed during processing by selection on the screen or by pressing the buttons on the remote control (optional).
A0 version Clinical Guide 7.1 Target population BioMoov is intended for anyone over 5 years of age, regardless of gender, in combination with the BioStim device, it cannot work alone. The clinical part is detailed in the Biostim user manual 7.2 Side effects...
Description of the anomaly Possible causes Actions No connection to Biostim Bluetooth connection problem -Check that the Biomoov is charged -Switching the Biomoov off and on -Click on the Bluetooth logo (under the house). No charging of the device USB cord problem...
11.2 Electronics If the BioMoov device should fail or become unusable, it is requested to return it to the manufacturer or to deposit it in a Recylum collection point. Indeed, as part of its commitment to the environment, Électronique du Mazet finances the...
Page 18 on 20 DATE 13/04/2022 A0 version 12 Transport and storage The device must be transported and stored in its original packaging or in packaging that protects it from external damage. Store in a clean, dry place at room temperature 13 CE declaration ÉLECTRONIQUE DU MAZET makes available on request the CE declaration of this device .
Page 19
Page 19 on 20 DATE 13/04/2022 A0 version Your dealer / distributor :...
.................. Declares to have received the Biomoov device n° ......in working order. I have received all the necessary instructions for its use, maintenance, care, etc... I have read the instruction manual and I have noted the warranty and service conditions.
Need help?
Do you have a question about the BIOMOOV and is the answer not in the manual?
Questions and answers