This mark on the unit warns that there are rotating parts inside this unit and there is a risk of getting your fi ngers caught. This mark on the unit indicates that there are hot parts inside this unit. Leslie 122H/142H Owner’s Manual...
For the USA NOTE: This equipment has been tested and found to comply with the limits for a Class B digital unit, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
MAIN FEATURES Th e Leslie Heritage Series (models 122H & 142H) is a meticulous recreation of the original Leslie 122/142 tone cabinets. Not only speakers and amplifi ers, but all the other elements related to the sound such as materi- als and shapes of cabinets and rotors are recreated.
142H 6-PIN DIN CONTROL TYPE 54 kg / 119.1 lbs MOTOR OPTIONAL Brushless DC Servo Motor x 2 11-pin Leslie Cable LC11-7M ROTOR 6-pin to 6-pin DIN Adapter Cable LCA-66 Horn Rotor, Wooden Low Rotor Foot switch FS-10TL/FS-9H ROTOR ADJUST...
Horn Rotor ❾ FOOT SW jack Reproduces the treble (above 800 Hz) frequencies. Allows you to control the Leslie rotors using the FS-10TL or FS-9H Foot Switch. When using the FS-9H, the rotors will Low Rotor ❷ switch between SLOW and FAST each time the Foot Switch is Reproduces the bass (below 800 Hz) frequencies.
Page 7
6-PIN DIN INPUT socket ⓫ Connects an organ equipped with a 5- or 6-pin Leslie adapter kit using a 6-pin to 6-pin DIN Adapter Cable LCA-66 (optional). CAUTION The Leslie Heritage Series cabinets accept 122-type out- put only. DO NOT attempt to connect another adapter kit interface (such as 147, 251, etc.) to this cabinet or se-...
Page 8
Low rotor for a few seconds after the power to the cabinet is turned “ON.” AC Power Cord Connect the female end of the AC Power Cord into the recep- tacle on the cabinet marked, “AC IN.” Leslie 122H/142H Owner’s Manual...
Page 9
PREPARING THE SPEAKER FOR USE Steps: Make sure the power to the cabinet is “OFF.” ① Locate the AC Power Cord that came with the cabinet. ② Connect the female end of the AC Power Cord into the re- ③ ceptacle on the cabinet marked, “AC IN.” Connect the 3-pronged Power Cord into a grounded AC ④...
Position it to the left [FS-10TL] when using an FS- 10TL and to the right [NON-LATCHING] when using a Hammond FS-9H or similar “non-latching/normally open” switch. NOTE: If your instrument has a built-in digital Leslie, turn it “OFF” when using this connection. Leslie 122H/142H Owner’s Manual...
Page 11
CONNECTING AN ORGAN WITH A 5- or 6-PIN LESLIE INTERFACE NOTE: Before attempting to connect the Heritage Series cabinets to a vintage organ, the organ needs to have a Leslie speed switch attached to the front rail. WARNING: Risk of Electric Shock!
Page 12
The rotors will automatically start rotating at FAST mode. After 6 seconds, the rotors will switch from FAST mode to the cur- rent speed according to the position of the Leslie switches on the organ or the Foot Switch setting.
Page 13
11-PIN POWER REMOTE FUNCTION (only for organs with a Leslie 11-pin socket) If you are connected to the cabinet using the 11-pin interface, you can use the 11-PIN POWER REMOTE function to turn the power to the cabinet “ON” using the power switch on the organ.
Page 14
SERVICE Hammond maintains a policy of continuously improving and upgrading its instruments and therefore reserves the right to change specifi cations without notice. Although every attempt has been made to insure the accuracy of the descriptive contents of this Manual, total accuracy cannot be guaranteed. Should the owner require further assistance, inquiries should fi rst be made to your Authorized Hammond Dealer.
Need help?
Do you have a question about the Heritage 122H and is the answer not in the manual?
Questions and answers