Important Safety Instructions - Shark HP100EU Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 6
NOTE: SAVE THESE INSTRUCTIONS. KEEP FOR FUTURE REFERENCE.

IMPORTANT SAFETY INSTRUCTIONS

HOUSEHOLD USE ONLY • READ ALL INSTRUCTIONS BEFORE USE
Unplug or disconnect the appliance
from the power supply before servicing.
WARNING
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK OR INJURY:
READ ALL THESE INSTRUCTIONS BEFORE USE.
1.
DO NOT operate with a damaged cord or plug.
Discard or return to an authorised service facility for
examination and/or repair.
2.
DO NOT run cord under carpeting. DO NOT cover
cord with throw rugs, runners, or similar coverings. DO
NOT route cord under furniture or appliances. Arrange
cord away from traffic area and where it will not be
tripped over.
3.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent, or similarly
qualified persons in order to avoid a hazard.
4.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
USE WARNINGS
5.
Children should be supervised to ensure that they DO
NOT play with the appliance. Keep the cord out of
reach of children.
6.
Cleaning and user maintenance should not be done by
children.
7.
Prior to cleaning or other maintenance, the appliance
must be disconnected from the supply mains.
8.
DO NOT handle plug or appliance with wet hands.
9.
DO NOT use without filter in place.
10.
Only use Shark ® branded filters and accessories.
11.
DO NOT damage the power cord:
a)
DO NOT pull or carry appliance by the cord or use
the cord as a handle.
b)
DO NOT unplug by pulling on cord. Grasp the
plug, not the cord.
c)
DO NOT stand the appliance on the power cord,
close a door on the cord, pull the cord around
sharp corners, or leave the cord near heated
surfaces.
READ AND SAVE THESE INSTRUCTIONS
visit qr.sharkclean.com/hp100eu or
SCAN HERE
USING YOUR SMARTPHONE CAMERA
FOR FULL INSTRUCTIONS, AND
REPLACEMENT PARTS.
12.
DO NOT use with any opening blocked; keep free of
dust, lint, hair and anything that may reduce airflow.
13.
DO NOT use if appliance is not working as it should,
or has been dropped, damaged, left outdoors, or
dropped into water.
14.
DO NOT place appliance on unstable surfaces such as
chairs or tables.
15.
DO NOT use in the following areas:
a)
Wet or damp surfaces
b)
Outdoor areas
c)
Spaces that are enclosed and may contain
explosive or toxic fumes or vapours (lighter
fluid, petrol, kerosene, paint, paint thinners,
mothproofing substances, or flammable dust).
16.
Turn off all controls before unplugging the appliance.
17.
Unplug from electrical outlet when not in use and
before any maintenance or cleaning.
18.
Hand wipe external surfaces with water only. Wiping
with cleaning chemicals could damage the unit.
19.
Make sure filter is in place after routine maintenance.
REMOTE CONTROL BATTERY WARNINGS
20.
The battery must be disposed of properly, including
keeping it away from children, as even used batteries
can cause injury.
WARNING: Chemical Burn Hazard. Keep batteries
away from children.
This product contains a lithium button/coin cell
battery. If a new or used lithium button/coin cell
battery is swallowed or enters the body, it can cause
severe internal burns and can lead to death in as little
as 2 hours. Always completely secure the battery
compartment. If the battery compartment does
not close securely, stop using the product, remove
the batteries and keep it away from children. If you
think batteries might have been swallowed or placed
inside any part of the body, seek immediate medical
attention.
Remove Enclosed Filter From
Packaging Before Operating
Please be sure to read and save the warnings on other side prior to using your unit.
QUICK START GUIDE
Your Shark® HP100 Series Air Purifier removes allergens, mould,
bacteria, and other particles from your air for confidence in the air you breathe.
SETTING UP YOUR UNIT
1
2
1.
2.
Take the filter out of its packaging,
First, carefully flip the air purifier upside
down and place it on a level surface.
then insert it back into the unit.
Twist the filter door to unlock and
DO NOT run the air purifier unless
remove the door.
the filter is removed from its packaging
and properly reinstalled.
4
5
8 cm
MAX
MAX
minimum
4
Set up the unit on a level floor surface, at
5.
Plug the unit into an electrical outlet and
least 8 cm away from walls and objects.
press the power button on the top of the
control panel. When the unit is powered
on, it will begin to analyse the air quality
indicated by the rotating lights.
TOP CONTROL PANEL BUTTONS
Auto Mode
Air Info
RECOMMENDATIONS
TIPS FOR YOUR CONTROL PANEL
EXAMPLES OF SITUATIONS THAT CAN
• Run on Auto Mode—your fan speed
will automatically adjust. As air quality
• Cooking
decreases, the fan speed will increase.
• Burning food
After 100% air quality status is achieved
for 10 minutes in Auto Mode, your air
• Dusting
purifier will enter Eco Mode. If particles are
detected, your fan will turn back on.
• Don't wash filters—they're designed to
perform optimally for 6–12 months on
their own.
© 2022 SharkNinja Operating LLC.
SHARK is a registered trademark in the European Union of SharkNinja Operating LLC.
sharkclean.eu
HP100EUSeries_QSG_MP_145X210_220429_MV1
3.
Remove filter
from plastic
packaging
3.
With the filter reinstalled, replace the
filter door. Twist the filter door until
clicks into place. To maximise your
air purifier's filter life, we recommend
flipping and rotating the direction of
your filter every three months.
visit qr.sharkclean.com
/hp100eu or
SCAN HERE
USING YOUR SMARTPHONE CAMERA
FOR FULL INSTRUCTIONS,
REPLACEMENT PARTS
AND GUARANTEE
Note: The air quality sensor uses a
cumulative particle count across all PM sizes
MAX
to determine percentage of clean air.
Brightness
Shut-Off Timer
WANT TO MUTE YOUR AIR PURIFIER'S
AFFECT AIR QUALITY
BEEPING?
• Smoking
• Allergy season
• Cleaning products
To control your unit's beeping, hold
the Air Info and Child Lock buttons
at the same time for two seconds.
Fan Speed

Advertisement

Table of Contents
loading

Table of Contents