We will however, pass on all warranties made by the manufacturer, who has sole responsibility for performing such warranties. Baja Designs will pay the freight if your product is less than 90 days old, otherwise defective products must be returned to Baja Designs, Inc., freight prepaid. At our option, we will repair or replace items in question and return them at no charge.
Page 3
(07-14) Silverado A-pillar kit Tools Required 9/16” Socket 9/16” Wrench 13mm Socket 1. Begin by locating the plastic cowling in between the bottom of the windshield and the hood. With light constant force, lift the cowling upward as shown in the picture below. 2.
Page 4
**Warning: while the hood is open, it is possible to remove the two bolts on either the driver or passenger side. This must only be done one side at a time to avoid the hood moving and it is strongly recommended to use an assistant to hold the hood open as a precaution.** 3.
Page 5
4. Connect the +12V (red wire) to the positive battery terminal and the -12V ground (black wire) to the negative battery terminal. Re-torque all the fasteners after 100 miles. Your install is now complete! Thank you for choosing Baja Designs.