Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for DaVinci Harmony PILOT
- Page 2 PILOT User manual Rev 1 SEP 2021...
-
Page 3: Thank You
To reduce the risk to the pilot, we invest and challenge a lot of research and development. We wish you a comfortable and safe flight with the Harmony pilot. -Davinci Gliders team-... -
Page 5: Warning
FROM A CERTIFIED PROFESSIONAL INSTRUCTOR IS EXTREMELY DANGEROUS TO YOURSELF AND BYSTANDERS. DAVINCI GLIDERS are carefully manufactured and inspected at the factory. Please use the harnesses only as described in this manual. Do not make any modifications to the harnesses. -
Page 6: Table Of Contents
Shoulder straps ......................... 20 Lateral Straps ........................21 Chest Strap ........................22 Lumbar Strap ........................23 Leg Strap ..........................24 Flying with the Harmony PILOT ....................25 General warnings and advice ...................... 25 Pre-flight checks ..........................25 Landing with the Harmony PILOT .................... -
Page 7: Introducing The Harmony Pilot
Introducing the Harness Harness speck Height (cm) 155-175 175-195 Weight (kg) 50-85 70-100 Board Width (cm) Board Depth (cm) Height of Suspension Point (cm) Harness Weight (kg) Back protection type Foam Min/Max container volume (cm3) 7000-8000 7500-8500 Certification The Harmony has EN 1651 and LTF NfL II91/09 certification, max load 120 DaN... - Page 8 Shoulder adjustment Back Storage Components and Features Chest buckle Container Leg buckles 30mm Al Components carabiner 1 Harness 2 30mm Al Carabinner 3 Honeycomb Seat Plate 4 Rescue handle+Inner container Honeycomb Seat Plate 1. Harness Foam Rescue protection Parachute handle 2.
-
Page 9: Before You Fly
Double check that your dealer has checked the integrity and basic settings of the harness. The harness should be assembled by appropriately qualified paragliding instructor. Harmony pilot harness doesn’t have accelerator system • Connecting the carabiner Before your flight, you have to... -
Page 10: Installing The Seat Plate
Installing the seat plate The seat plate can be removed and accessed on the back of the seat. Disconnect the leg strap and pull it back to remove it. Place the leg straps on the back edge of the sheet when installing the seat plate. The seat plate must be installed with the rounded edge to the backward and the front curve facing downward. -
Page 11: Rescue Installation And Compatibility Check
The pilot is responsible for ensuring the parachute is properly installed. This harness is compatible with the Davinci Gliders’s Comma # lite. The rescue from other manufacturers can also be used, we do not guarantee each function. -
Page 12: Attaching The Rescue Deployment Bag To The Harness Deployment Handle
Attaching the rescue container bag to the harness rescue parachute handle Harness is included the rescue parachute handle. The handle have to be connected to the rescue container bag. For the connection, you have to check the length of the strap. It must be longer than the connecting plastic pin not being pulled before the strap tightens on the reserve. -
Page 13: The Rescue Deployment Bag And The Harness Deployment Handle
Be sure to contact your parachute dealer or a qualified professional to check the connection, position and secure deployment, and refer to the rescue manual for details. The rescue handle and inner container supplied with the Harmony PILOT should already be connected. -
Page 14: Rescue Inner Bag Packing
Rescue inner bag packing Your rescue should be repacked into the supplied inner containers as follows. -
Page 15: Connecting The Rescue Bridle
Connecting the rescue bridle To connect your rescue to the Harmony PILOT harness, we recommend using a Davinci Rescue Carabiner which has Min 28kN(2854kgf) of breaking load. It has more than 10 times of your maximum weight. Be sure to inspect your connector during normal maintenance and safety checks. -
Page 16: Rescue Installation Guide
Rescue installation guide The right installation of rescue parachute is the most importance process. Begin by first connecting the bridle and the rescue handle to the rescue parachute (p.-). -Set the rescue into the rescue pocket of the harness with the handle connection close to the pilot and the extra rescue bridle and connection lines neatly folded at the bottom of the container. -
Page 19: Adjustments
Adjustments Adjust your harness to fit your body type and flight style. It is important to adjust correctly so that you can slide easily into the sitting position after takeoff. A misaligned harness can negatively affect the flying characteristics of a paraglider. Hang on the simulator to make adjustments before the first flight and fine the right settings if necessary during the first few flights. -
Page 20: Shoulder Straps
(1) Shoulder straps The optimum setting for the shoulder straps depends on the height of the pilot. Step into the harness and stand upright with the breast strap closed, symmetrically adjust the shoulder straps until they are a snug fit, but not tight. To tighten: pull down on the BLACK webbing strap(1) To loosen: pull up on the Black webbing strap(2) -
Page 21: Lateral Straps
(2) Lateral Straps The lateral strap can adjust the angle between the thigh and back. Increasing the strap increases the angle, and decreasing the angle. The most comfortable position for yourself is to adjust in flight from calm weather. The attitude of flying in a reclining position reduces the stability of the harness and increases the possibility of twist of the riser. -
Page 22: Chest Strap
(3) Chest Strap The adjustment of the chest strap controls the distance between the carabiners and affects the handling and stability of the glider. Widening the distance between the carabiners increases feedback from the wing and allows for easier weight shifting. Closing the strap gives you a more stable feeling in turbulence but increases the risk of stable spiral and also the risk of twisting! The chest strap may also be adjusted in flight according to the conditions;... -
Page 23: Lumbar Strap
(4) Lumbar support For optimal ergonomic support in the lower lumbar region and adjustment of the sitting depth. To tighten, pull forward on BLACK webbing strap(1) To loosen, pull back on the BLACK webbing strap(2) -
Page 24: Leg Strap
(5) Leg straps The roots of the leg straps are positioned high, a characteristic of the Get-Up system, and this ensures great freedom of movement for the legs. Generally, the factory setting are correct. If it is difficult to enter the harness after launch, we suggest tightening the leg strap adjustment under the seat. -
Page 25: Flying With The Harmony Pilot
Flying with the Harmony PILOT General warnings and advice Before every flight, check the following Are you in good physical and mental condition? Are you familiar and compliant with all applicable laws and regulations in your area? Are you briefed thoroughly about the site, airspace and expected weather conditions of the day? -
Page 26: Landing With The Harmony Pilot
When you landed with the Harmony PILOT , you have to check the rescue parachute handle which is the right position and whether the rescue is opened. -
Page 27: Maintenance And Repairs
Care and maintenance Don’t draggle the Harmony PILOT on rough or rocky ground Avoid unnecessary exposure to UV, heat and moisture. Store all equipment in a cool, dry place and never store them in wet or wet conditions. - Page 28 If there is a problem with the equipment, the Davinci dealer should be the first to contact you. If you are unable to contact the dealer or the importer of the Davinci, contact the Davinci Glider directly through our website (www.flydavinci.com) Care of the environment We have the privilege of flying, which is difficult for anyone to enjoy in outstanding nature.
-
Page 29: Activate The Reserve Parachute
Activate the reserve parachute It is a good idea to check the position of the reserve parachute handle frequently during flight whenever you can afford it. By doing so, you will be able to maximize the time given the paraglider throws a reserve parachute out of control. -
Page 30: Materials
Materials Harness Fabric code 210D Rip stop Nylon Outer 1000D KODRA Fabric Inner 70D EXTREEMA R/S Webbing Nylon 25mm Thread 210D/9, D/6 Bonded Plyester... - Page 31 An attitude altitude 53 Shinchon-gil, Okcheon-myeon, Yangpyeong-gun, Gyeonggi-do, Republic of Korea www.flydavinci.com...