TaoTronics TT-AH016 User Manual page 6

2. Setting the humidity level to "--" turns off humidity mode. You may also tap and hold the
Humidity Button at any time to turn it off.
Mist Adjustment
Tap the Mist Button to change between the 3 mist output levels. There will be a beep
sound with each tap and the LED display will update accordingly.
Sleep Mode
1. Tap the Sleep Button to enter sleep mode. The LED display and all button colors will turn
off, except for the Sleep Button (which will dim to half brightness).
2. In sleep mode, all buttons remain functional . Tap any button except the Power Button to
wake up the LED display and all of the buttons.
3. When the LED display is active, tap the Sleep Button again to turn off sleep mode.
Memory Function
If power was not disconnected, the humidi er will remember the mist setting from the time
it was last turned off.
Remote Control
1. All buttons on the remote control function the same way as on
the humidi er.
2. Aim the remote control at the LED display of the humidi er for
better response.
3. The effective range between the remote control and the product
is 4 meters / 157.5 in.
Low Water Protection
When all water inside the tank has been depleted, the humidi er will turn off automatically
and the low water icon will light up.
Cleaning and Maintenance
1. Fill the water tank half full, and add in 100ml white vinegar. Run the humidi er for 5-10
minutes to allow the vinegar/water mixture to work through and loosen up the gunk.
2. Turn off the humidi er, unplug it, and drain the water. Cover the air outlet with the
protection cap, then wipe out the inside of the diffuser with the included cleaning brush.
Air Outlet
3. Pay special attention to clean the water level sensor, as it often causes the most issues
when it gets dirty. You can use a drop of lemon essential oil on your brush or q-tip if you
need to cut through extra grime. (Be extra careful when you drain water to avoid water
getting into the underside or motor area to ruin the product).
4. Use a soft cloth to wipe down the outside of the machine to remove any ngerprints,
smudges, etc. The cloth can be dampened with water, or you may lightly spray it with a
bit of gentle cleaner or vinegar/water solution.
5. Clean the humidi er once a week.
Protection Cap
03/04