Advertisement
TESLA 4000-SV Power System Recorder
In our ongoing efforts to run our business in an environmentally sensitive way, we are encouraging
the use of PDF manuals and software downloads, available from our website. For your convenience,
links are provided below to all software files to be downloaded
If you do wish to have a hard copy manual or software on CD, you may request those from our
Customer Support team (contact info below).
If you are reading a hard copy of this document, download the soft copy (includes links) from
our website's Support/Documents page, in the Quick Start Guide column.
http://www.erlphase.com/support.php?ID=documents
1. Downloading the Required Software and Manual
a. The TESLA 4000-SV comes loaded with the requested firmware version. All required
software, as well as the release description of the latest firmware version, is available on
the
Software page
descriptions of any other firmware version.
b. Download the following software on your computer:
TESLA C
USB Driver
ERL 61850 IED Configurator
HyperTerminal (or equivalent Terminal Emulation Application)
c. Install TESLA Control Panel
d. Install the USB driver (refer to Section 5 in this guide)
e. Install Null Modem (refer to Section 3 in the user manual)
The TESLA 4000-SV user manual and other documents such as drawings are also available on
the
Documents Page
of our website.
2. PC Hardware and Operating System Requirements
Minimum hardware requirements:
•
1 GHz processor
•
2 GB RAM
•
20 GB available hard disk space
•
USB port
•
Serial communication port (optional)
•
Windows 7 Professional or Windows 10 Professional
Quick Start Guide for
of our website. Contact our Customer Support team for release
ontrol
Panel
.
Advertisement
Table of Contents
Related Manuals for ERL TESLA 4000-SV
Summary of Contents for ERL TESLA 4000-SV
- Page 1 Install the USB driver (refer to Section 5 in this guide) e. Install Null Modem (refer to Section 3 in the user manual) The TESLA 4000-SV user manual and other documents such as drawings are also available on Documents Page of our website.
- Page 2 The wire used for the power supply wiring shall be at least 18 AWG (1.02 mm2), 600 V. c. There are no analog terminals for TESLA 4000-SV Sampled value subscriptions must be configured via the ERL 61850 IED Configurator tool for the TESLA to acquire to analog input data from merging units. Refer to “Sampled Value Setup Requirements”...
- Page 3 Figure 2 – TESLA 4000-SV Rear Panel Figure 3 – TESLA 4000-SV Rear Panel (With Redundancy) Not all possible ordering configurations are shown in the diagrams above.
- Page 4 (scroll to the Configuration section). • TESLA 4000-SV Sampled Values-Based Fault and Disturbance Recording 5. Video Tutorials Watch the following video tutorials to guide software installation and basic communication setup. The videos can be accessed from the Support section of our website on the...
Need help?
Do you have a question about the TESLA 4000-SV and is the answer not in the manual?
Questions and answers