biochrom ZENYTH 200 Quick Start Manual

BIOCHROM ZENYTH 200 MICROPLATE READER
QUICK START GUIDE

1. Turn on the instrument:

Connect instrument to a power source using the appropriate power cord.
 Check user's manual for important safety information.

2. Connect the instrument to a PC:

Connect to a PC via serial port to serial port or a serial port to USB port adaptor. To
determine the communication port (com) used by the instrument, and open the device
manager, found here: go to Start\Control Panel\System\Hardware\Device Manager\Ports.
Please Note:

Ensure that the instrument is connected using COM ports 1 – 9.

Some USB to RS232 converters do not work well; use a serial port whenever
possible.

Ensure that you are using the original RS232 cable that was shipped with the
instrument.

3. Connect instrument to ADAP software:

Insert CD supplied with the instrument into PC; install ADAP. Open ADAP. ADAP will prompt
for a user ID and password. Use the pre-set ID and password: sadmin\sadmin. Once logged
as sadmin, set specific user IDs, passwords and administrative rights. Select
Setup>Instrument in the menu bar. A dialogue box will open:
March 11
Under the Instrument tab:



Zenyth 200 Quick Start Guide
In Baudrate: select Auto Sense
In COM Port: select port
In Instrument Type: select Zenyth200
Version 2.0