Advertisement
Trash Pullout Installation Instructions
Installation Instuctions for TPOS15, TPOD18, AND TPOD21
• Drill
• Craft33 Wax Fill Stick
• Trash insert
• Plastic Receivers
• Double-sided Foam
Tape
TRASH AND CABINET CONFIGURATION
TPOD18 (double trash)
TPOD21 (double trash)
REQUIRED TOOLS
Trash Pull Out
TPOS15 (single trash)
• Using Jig #1, drill holes inside
back left and right corners
of cabinet.
This is where the plastic receiver
will be mounted for the glides.
SEE STEP 3.
• Jig #1, #2, and #3
• Magic Eraser
®
• Glides
• Orange Receivers
• Screws
Base Cabinet
B15 or BFH15
B18 or BFH18
B21 or BFH21
STEP 1
8/18
Advertisement
Table of Contents
Summary of Contents for Craft33 TPOS15
- Page 1 Trash Pullout Installation Instructions Installation Instuctions for TPOS15, TPOD18, AND TPOD21 REQUIRED TOOLS • Drill • Jig #1, #2, and #3 • Craft33 Wax Fill Stick • Magic Eraser ® • Trash insert • Glides • Plastic Receivers • Orange Receivers •...
- Page 2 STEP 2 • Remove glides from box. • Install plastic receivers into back left and right side of cabinet box where holes were drilled in STEP 2. Plastic Receiver STEP 3 • Install glides by sliding plastic receiver into the back of the cabinet.
- Page 3 Jig #1 (or a level) QUESTIONS? If you happen to have any questions or concerns during installation, please feel free to reach out to a Craft33 Customer Care representative, and we will be happy to walk you through the process. Craft33 (234) 226-4915 craft33products.com...
Need help?
Do you have a question about the TPOS15 and is the answer not in the manual?
Questions and answers