Summary of Contents for CKvision CK-HDT24-70W-4DT
- Page 1 Please be careful before use Read this instruction manual Digital light source controller CK-HDT24-70W-4DT...
- Page 2 D i gi ta l lig h t s o urce co n t ro ll e r CK-HDT24-70W-4DT K-HDT24-70W-4DTIt is a four-way high-power multi-function light source controller, with two light source driving modes: splash screen and long light, multiple function settings, easy to use.
-
Page 3: Power Switch
50/60Hz； Turn the switch on the right end to "0" to turn off the main power supply, and turn it to "1" to turn on the 2.RS232 Interface： Connect the serial communication cable to the host computer, through the CKvision builder can adjust the brightness of the light source and soft trigger。 · Protocol： RS232 ·... -
Page 4: Trigger Output
The controller receives the rising edge/falling edge signal of the pulse of the trigger port (can be selected by the switch of serial number 9), the controller drives the light source of the corresponding serial number, and outputs the pulse signal to the corresponding trigger output (CAMERA) port, triggering the camera to take pictures。... - Page 5 二、 the mode introduction This digital light source controller has two working modes: long light and splash screen： Long light mode, that is, after the controller receives a valid trigger signal (rising edge/falling edge)Continue to drive the light source, and stop driving the light source until the reverse change of the trigger level is detected。...
- Page 6 1.2 CKThere are two states: pulse and continuous light source control tool： The pulse status is mainly used for high -precision camera to take pictures. The sensor sends a signal to the light source controller. The camera triggers the camera through the light source controller, and the accuracy can reach microseconds.
- Page 7 2.2.Adjust the brightness of each channel to 100 Send directly "i96 = 100 i97 = 100 i98 = 100 i99 = 100 savei" The ending character selects "Enter” 3、 Continuous state control by sending text tools M11, M21, M31, M41 corresponding to 1 to 4 channels respectively; Value 1 is to open the light source, and the value 0 is to turn off...
- Page 8 3.2.Turn off the continuous opening of the first channel Send "M11 = 0" directly The ending character selects "Enter” 4、 Directly control the light source through this machine Control through the switch button knob on the right side of the LED display, press and switch the light source channel, and rotate the brightness。...
- Page 9 Follow the official wechat account...