Table of Contents
Advertisement
en Troubleshooting
Fault
All other error codes.
"E:30/-20"
The appliance is not
working.
The programme does
not start.
48
Cause and troubleshooting
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 57
Solenoid valve defective.
Call the after-sales service.
▶
→ "Customer Service", Page 57
Detergent dosage is too high.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Additional water is added.
Do not add any extra water to the appliance while it
▶
is operating.
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker is faulty.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
You have not pressed
Press
.
▶
Door is not closed.
Close the door.
1.
Press
to start the programme.
2.
Childproof lock is activated.
→ "Deactivating the childproof lock", Page 33
▶
- + is activated.
Check whether - + is activated.
▶
→ "Buttons", Page 24
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press
to start the programme.
4.
The detergent drawer has not been pushed in as far
as it can go.
Push the detergent drawer in as far as it will go.
▶
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
.
Advertisement
Table of Contents
