Cellink AC-0442 Installation Manual

AC-0442
15 ELEMENT
YAGI ANTENNA
1/ Taking note of the antenna drain hole - slide the antenna Ubolts over the vertical boom
and tighten the nuts.
2/ Attach the feed cable
Secure the cable to the vertical
3/ Fit mating connector
signal level.
If the signal level is unsatisfactory
bracket and adjust the ante nna angle for the best signal.
4/ Replace the angle adjustment
5/ Seal the connector
Ubolts
Waterproofing on connectors
AC-0442
INSTALLATION GUIDE
NEXT G
NOTE: These connectors must be covered with a waterproofing substance.
(not supplied) to the antenna and run it down to the equipment.
boom with cable ties (not supplied).
to the feed cable and attach test equipment.
- loosen the angle adjustment
screws and lock the antenna angle into place.
union with a waterproofing
NOTE: Cable must be kept in
close to the boom and clear of
the antenna elements.
NOTE: cable must be kept clear of the reflector.
NOTE: Drain Hole must be on this side.
Check for a suitable
screw on the angle
compound.
20.0°
Vertical Mounting Boom
Angle
adjustment
screw
Phone: (03) 5334 2513
Web: www.wiltronics.com.au