Subscribe to Our Youtube Channel
Related Manuals for ClearSounds CS-WS1
Summary of Contents for ClearSounds CS-WS1
- Page 1 ™ C O M M U N I C A T I O N S Wake & Shake ™ Large Display Alarm Clock & Telephone Ring Signaler User’s Guide...
-
Page 2: Important Safety Instructions
3.Do not use this product near or in water or when you are wet. If the product comes in contact with any liquid, unplug the power cord and telephone cord immediately. Do not plug the product back in until is has dried completely. - Page 3 Description %:)$...
-
Page 4: Installation
Your Wake & Shake offers you the option of using it as both an alarm clock and a telephone ring signaler. The following diagram shows you how to set up your Wake & Shake so you may use it for both. - Page 5 How To Set The Time 1. Press and hold the Time button. 2. Holding down the Time button, press the hour button, then the minute button until the correct hour appears. 3. Release the Time button. NOTE: There is a PM indicator on the top left of the display. How To Set The Alarm Time 1.
-
Page 6: Snooze Key
When the alarm is set to one of the modes, the alarm indicator will appear on the display. Your Wake & Shake distinguishes between the clock alarm and telephone ring alarm by using different patterns. See the table below: ALARM MODE SOUND... -
Page 7: Alarm Off Button
1. Make sure your Wake & Shake has been installed using the phone cord and is plugged into your telephone wall jack. 2. Adjust the Ringer On/Off switch to A+T (for clock alarm & telephone alarm) or T (for just telephone alarm). -
Page 8: Volume And Tone Control
Volume and Tone Control Your Wake & Shake allows you to adjust both the volume and tone of the alarm. The Volume Control increases or decreases the loud- ness of the alarm. The Tone Control shapes the sound by making it a higher pitch or a lower pitch. -
Page 9: Limited Warranty
Shake Clock against any defect in materials or workmanship for the period of one year from the date of purchase. Within a period of one year from purchase date, ClearSounds Communications will repair or replace (our discretion) your WS1 Wake & Shake Clock at no cost. If we elect to replace your clock, we may replace it with a new or reconditioned product of the same or similar design. -
Page 10: Regulatory Compliance
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company. A plug and jack used to connect this WS1 to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. - Page 11 If trouble is experienced with this telephone equipment, for repair or warranty information, please contact ClearSounds Communication at 1-800-965-9043. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equip- ment until the problem is resolved.
- Page 12 8160 Madison Ave., Burr Ridge, IL 60527 800.956.9043 V — 800.536.8890 TTY 630.654.9219 FAX • www.clearsoundscom.com...
Need help?
Do you have a question about the CS-WS1 and is the answer not in the manual?
Questions and answers