Gigabyte Z790 AORUS MASTER User Manual page 25

10) NOISE_SENSOR (Noise Detection Header)
This header can be used to connect a noise detection cable to detect the noise inside the case.
For more information on the noise detection function, please navigate to the "Unique Features"
page of GIGABYTE's website and search for "FAN CONTROL."
Before connecting the cable to the header, make sure to remove the jumper cap; re-place the
jumper cap if the header is not in use.
11) SATA3 4/5/6/7 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The SATA connectors support RAID 0,
RAID 1, RAID5, and RAID 10. Please navigate to the "Configuring a RAID Set" page of GIGABYTE's
website for instructions on configuring a RAID array.
To enable hot-plugging for the SATA ports, please navigate to the "BIOS Setup" page of GIGABYTE's
website and search for "SATA Configuration" for more information.
1
7
7
5 7
SATA3
4 6
- 25 -
Pin No. Definition
1
2
Noise Detection
Cable
1
Pin No. Definition
1
1
2
1
3
4
5
6
7
Noise Detection
GND
GND
TXP
TXN
GND
RXN
RXP
GND