Table of Contents
Advertisement
Scaler Switcher with Digital Amplifier-TN (12 inputs)
Scaler Switcher with Digital Amplifier-TN can be connected with a router to make up a
LAN with the PC(s), this make it able to be controlled in a LAN. Make sure Scaler
Switcher with Digital Amplifier-TN's IP section is the same with the router. Please
connect like the following figure for LAN control.
Step1. Connect the TCP/IP port of Scaler Switcher with Digital Amplifier-TN to
Ethernet port of PC with twisted pair.
Step2. Set the PC's IP address and gateway to the same IP section as Scaler
Switcher with Digital Amplifier-TN's. Do remember the PC's original IP address
and gateway.
Step3. Set Scaler Switcher with Digital Amplifier-TN's IP address and gateway to the
same IP section as the router's.
Step4. Set the PC's IP address and gateway to the original one.
Step5. Connect Scaler Switcher with Digital Amplifier-TN and PC(s) to the router. PCs
in the same LAN are able to control Scaler Switcher with Digital Amplifier-TN
asynchronously.
The HDBT port of Scaler Switcher with Digital Amplifier-TN is used for TCP/IP control.
And all the control commands are the same as the RS232 command list. Here is the
detailed introduction.
4.4.5.
Control Scaler Switcher with Digital Amplifier-TN via TCP/IP
communication software
(Exampled by TCPUDP software)
1) Connect a computer and Scaler Switcher with Digital Amplifier-TN to the same
network. Open the TCPUDP software (or any other TCP/IP communication
software) and create a connection, enter the IP address and port of Scaler Switcher
with Digital Amplifier-TN (default IP: 192.168.0.178, port:4001):
16
Advertisement
Table of Contents
