Remove The Base Assembly For Vesa Mounting - Philips E Line 346E2 User Manual

2. Setting up the monitor
• MPRT is gaming-optimized mode. It is
recommended to turn off when you
are not using the gaming function.
Resolution notification
This monitor is designed for optimal
performance at its native resolution, 3440
x 1440 When the monitor is powered
on at a different resolution, an alert is
displayed on screen:Use 3440 x 1440 for
best results.
Display of the native resolution alert can
be switched off from Setup in the OSD (On
Screen Display) menu.
Physical Function
Tilt
20˚
Height
Warning
• To avoid potential screen damage,
such as panel peeling, ensure that the
monitor does not tilt downward by
more than -5 degrees.
• Do not press the screen while adjust-
ing the angle of the monitor. Grasp
only the bezel.
-5˚
100mm
2.3 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the monitor
base, please follow the instructions below
to avoid any possible damage or injury.
1. Place the monitor face down on a
smooth surface. Pay attention not to
scratch or damage the screen.
2. While keeping the release button
pressed, tilt the base and slide it out.
Note
This monitor accepts a 100mm x 100mm
VESA-Compliant mounting interface.
VESA Mounting Screw M4. Always contact
manufacturer for wall-mount installation.
100mm
Note
Please purchase the appropriate wall
mount; otherwise the distance between
the back-plug-in signal cable and the wall
would be too short.
9
100mm