Zenith A25A76ROM Operating Manual page 7

Hook Up Your Cable (CATV) and VCR
Locate the Antenna/Cable jack on
1
the back of your Entertainment
Machine.
Connect the cable that runs from
2
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
3
and put in two AAA batteries.
back of
remote
4 Plug in your TV. Do not plug it
into a switched outlet. Your
Entertainment Machine is
designed to operate on household
current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC
Current.
5 Go to page 9 to Auto Program
your Entertainment Machine.
Leave your VCR and your television
tuned to channel three and use
the cable box to change channels.
Remember, when screwing in RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
No A/V cables are included
with your Entertainment Machine.
Without A/V cables, most VCRs
will not play videocassettes in
stereo sound.
206-3450-O
Cable to TV with VCR
Cable TV
wall jack
Round wire (75 ohm)
TV back
TV back panel
(expanded view)
Audio In Video
Antenna
Cable
Cable with Cable
Box to TV with
Cable TV
wall jack
VCR
In
Out
Round wire (75 ohm)
TV back panel
(expanded view)
Audio In Video
Antenna
Cable
I N S TA L L AT I O N
VCR back
VCR back AV panel
output
In
Out
Video
RF coaxial wire
(75 ohm)
not included
with TV
A/V cables
not included
with TV
VCR back
Cable box
output
switch 3 4
VCR back AV panel
output
In
switch
Out
Video
TV back
RF coaxial wire
(75 ohm)
not included
with TV
A/V cables
not included
with TV
S TA N DA R D P A G E 7
Connect your
VCR and
Cable to your
Entertainment
Machine.
3 4
switch
Audio
3 4
Audio