Channel Settings; Channel - Magnavox MDR867H Owner's Manual

Channel Settings

Be sure the RF Cable is correctly connected to this unit and you
are Registered with your Cable Digital TV provider when you
install Cable Channels.
1
Press [ HOME ] then Select "Settings" using
[ K/ L/ 0 / 1 ] then press [ OK ].
2
Select "Channel Settings" using [ K/ L ] then
press [ OK ].
3
Select a desired item using [ K/ L ] then
press [ OK ].
4
Press [ (EXIT) ] to Exit.

Channel

1
Select "Channel" using [ K/ L ], then press
[ OK ].
EN - 60
Auto Channel Preset
If you Switch input signal wires (e.g. between Antenna and
CATV) or if you move the unit to a different area after the
Initial Setting or if you restore the DTV Channels you Deleted,
it is recommended to search a new Channel.
2
Select "Auto Channel Preset" using [ K/ L ],
then press [ OK ].
• The password will be required if you have locked
Channels. Refer to 'Channel Lock' on page 62.
3
Select a desired item using [ K/ L ], then
press [ OK ].
To scan Digital Over-the-Air
Broadcasting.
Antenna
To scan Digital Cable Broadcasting.
Cable
• Channel search will begin.
4
Press [ OK ] to complete Channel scan.
• Press [ (EXIT) ] to Exit.
Note(s)
• After setting "Auto Channel Preset", using [ CH +/− ]
Skips unavailable Programs automatically.
• If you are not receiving a signal from your Cable service,
contact the Cable provider.
• If you Select "Back" by pressing [ OK ] during "Auto
Channel Preset", the setup of TV Channels will be
canceled.