Table of Contents
Advertisement
Quick Links
E6850 CONNECT WIRELESS HEARING PROTECTOR
featuring Bluetooth wireless technology
Basic Operation
Charging the Headset:
Your hearing protector has been shipped to you with only a partial
charge on its integrated lithium ion battery pack. To charge the hearing
protector, insert the supplied Type-C connector cable into the Type-C
jack located on the bottom of the right cup of the hearing protector.
Connect the other end of the cable to a suitable USB power source
such as a computer or third party certified (UL, Intertek, etc.) AC to
USB wall adapter.
The LED will be blink blue while charging and change to solid blue
when complete.
Power：
Press and hold power button for 2 seconds to power ON/OFF headset.
Low Battery Warning:
Hearing protector will also provide a "Battery Low" warning by bleeping voice
when battery voltage is low.
Auto Shut-Off:
5 minutes after either Bluetooth or the audio input is disconnected, the hearing
protector will automatically power down. After auto shut-off, press and hold the
ON/OFF button for 3 seconds to turn back on.
Fitting the Headset:
Fully extend sliders and place cups over ears.
Then, tighten headband using sliders.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for PROTEAR E6850
- Page 1 E6850 CONNECT WIRELESS HEARING PROTECTOR featuring Bluetooth wireless technology Basic Operation Charging the Headset: Your hearing protector has been shipped to you with only a partial charge on its integrated lithium ion battery pack. To charge the hearing protector, insert the supplied Type-C connector cable into the Type-C jack located on the bottom of the right cup of the hearing protector.
- Page 2 Once powered on, the LED will be blink blue. Make sure your Bluetooth enabled device is scanning/searching for devices. Check your device to make sure it has discovered “E6850” Select “E6850” to connect to the hearing protector. Once connected successfully, the LED on the right cup will turn blue.
- Page 3 FCC Caution： This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the E6850 and is the answer not in the manual?
Questions and answers