Advertisement
Available languages
Available languages
ASSEMBLY
1.
Install both the interior pipe (11) and Exterior Pipe (13) with the base (14), the weight unit (15), lock
them by tightening the locking plate(16) and locking screw (17) together.
2.
Put the motor unit (6) onto the interior pipe (11), tightening the fixing screw (10).
3.
Install the rear guard, then lock it by turning the rear guard Nut (4) clockwisely.
4.
Insert the blade(2) into the motor shaft, fix it by tightening the screw (3)
5.
Put the front guard (1) and rear guard(5) together, fix them with fixing buckles and safety screw sets
provided.
Explode view
1.
Front Guard
2.
Blade Fixing Nut
3.
Blade
4.
Rear Guard Nut
5.
Rear Guard
6.
Motor Unit
7.
Oscillation Switch
8.
Power Cord
9.
Speed Control
10.
Fixing Screw
11.
Interior Pipe
12.
Pipe fixing screw
13.
Exterior Pipe
14.
Base
15.
Locking Screw
Operating Instructions:
a) Ensure voltage used corresponds with the voltage indicated.
b) Turn the speed control to selected speeds: 0(off) and speeds1, 2, 3 is Slow, Middle, Fast.
c) Tilting angles-By pushing the tilt-guard, you can adjust the fan to any elevation preferred.
d) Never touch the blades with hand or any object!
e) Do not pull the cord too hard. If damaged after pro-long use, get it repaired by any electrical repairman.
f) To clean: Disconnect the power cord from the mains. Remove the guard and the blades carefully. Do not
drop the blades! First use soft cloth with light soap to clean off oil stains. Then wipe and polish with dry
cloth. Never use polish or any corrosive liquid that will damage the paint, metal or plastic! Put back the
blades and lock the guard securely before use.
NO exchange will be entertained if the above instructions are not followed. Always Test the product first
before purchase.
7
Advertisement
