Table of Contents
Advertisement
Cleaning Your Microwave Oven
The following parts of your microwave oven should be cleaned
regularly to prevent grease and food particles from building up:
•
Inside and outside surfaces
•
Door and door seals
•
Turntable and Roller rings
ALWAYS ensure that the door seals are clean and the door
closes properly.
1. Clean the outside surfaces with a soft cloth and warm, soapy water. Rinse and
dry.
2. Remove any splashes or stains on the inside surfaces or on the roller ring with
a soapy cloth. Rinse and dry.
3. To loosen hardened food particles and remove smells, place a cup of diluted
lemon juice on the turntable and heat for ten minutes at maximum power.
4. Wash the dishwasher-safe plate whenever necessary.
DO NOT spill water in the vents. NEVER use any abrasive
products or chemical solvents. Take particular care when
cleaning the door seals to ensure that no particles:
•
Accumulate
•
Prevent the door from closing correctly
Clean the microwave oven cavity right ofter each use with a mild
detergent solution, but let the microwave oven cool down before
cleaning in order to avoid injury.
Installation & Wiring Instructions
IMPORTANT NOTE :
The mains lead on this equipment is supplied with a mouldedplug incorporating a
fuse.
The value of the fuse is indicated on the pin face of the plug and, if it requires
replacing, a fuse approved to BS1363 of the same rating must be used.
Never use the plug with the fuse cover omitted if the cover is detachable. If a
replacement fuse cover is required, it must be of the same colour as the pin face
of the plug.
Replacement covers are available from your Dealer. If the fitted plug is not
suitable for the power points in your house or the cable is not long enough to
reach a power point, you should obtain a suitable safety approved extension lead
or consult your Dealer for assistance. However, if there is no alternative to cutting
off the plug, remove the fuse and then safely dispose of the plug. Do not connect
the plug to a mains socket, as there is a risk of shock hazard from the bared
flexible cord.
Wiring Instructions
WARNING THIS APPLIANCE MUST BE EARTHED.
This appliance must be earthed. In the event of an electrical short circuit, earthing
reduces the risk of electric shock providing an escape wire for the electric current.
The appliance is equipped with a mains lead which includes an earth wire for
connecting to the earth terminal of your mains plug. The plug must be plugged
into a socket that is properly installed and earthed.
The wires in this mains lead are coloured in accordance with the
following code:
•
Green-and yellow
•
Blue
•
Brown
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings indentifying the terminals in your plug,
proceed as follows.
Connect the green-and yellow wire to the terminal in the plug marked with the
letter E or the earth symbol (
Connect the blue wire to the terminal marked with the letter N or coloured
black.
Consult a qualified electrician or service technician if in doubt
about any of these instructions.
The manufacturer of this oven will not accept any liability for
damage to persons or material for non observance of these
requirements.
There are no user+serviceable parts inside the oven and if the
mains lead of this appliance is damaged, it must only be replaced
by qualified service personnel approved by the manufacturer
because special tools are required.
WARNING
Ensure that the plug and power cord are not
damaged before use.
If you have any reason to remove the moulded plug
from this appliance, immediately remove the fuse
and dispose of the plug.
Do not connect the plug to a mains socket under
any circumstances as there is a danger of electric
shock.
CIRCUITS
Your microwave oven should be operated on a
separate circuit from other appliances. Failure to do
this may cause the circuit breaker to trip, the fuse to
blow, or the food to cook more slowly.
15
: Earth
: Neutral
: Live
) or coloured green or green-and-yellow.
GB
Advertisement
Table of Contents
