Advertisement
The purpose of this manual is to explain correct way how to integrate module WML-C95 to the end product. It
includes procedures that shall assist you to avoid unforeseen problems. This manual presents information that
shows how module and OEM product, where module integrated, complies with regulations in certain regions. Any
modifications, not expressly approved by the manufacturer could void the authority to operate in these regions.
Content
1. General
This MITSUMI Bluetooth HCI Module, model WML-C95 has to be installed and used in accordance with the
technical description/installation instructions provided by the manufacturer.
For detail information concerning type approval of this module, please contact the authorized local distributor or
manufacturer.
The system may only be implemented in the configuration that was authorized. Note that any changes or
modifications to this equipment not expressly approved by the manufacturer could void the user's authority to
operate this equipment.
2. Product Information
WML-C95 is a Bluetooth HCI Module. The specification is shown in the following.
Power Supply
Version
Carrier Frequency
Output Power
Hopping
Modulation Method
Data rate
Host interface
User Manual
MITSUMI Bluetooth HCI Module
MODEL WML-C95
VBAT:DC 2.97V to 3.63V (3.3V Typ)
VIO:DC 1.7V to 1.98V (1.8V Typ) or 2.97V to 3.63V (3.3V Typ)
Bluetooth V4.0 BDR/EDR+LE
2.402GHz to 2.480GHz
0 dBm (Class 2)
1600hops/sec
GFSK, PI/4-DQPSK, 8DPSK
GFSK: 1Mbps , PI/4-DQPSK: 2Mbps , 8DPSK: 3Mbps
UART, PCM (I2C)
Page 1 of 4
WML-C95_User_Manual
Advertisement
Table of Contents
Related Manuals for Mitsumi WML-C95
Summary of Contents for Mitsumi WML-C95
- Page 1 MITSUMI Bluetooth HCI Module MODEL WML-C95 The purpose of this manual is to explain correct way how to integrate module WML-C95 to the end product. It includes procedures that shall assist you to avoid unforeseen problems. This manual presents information that shows how module and OEM product, where module integrated, complies with regulations in certain regions.
- Page 2 Page 2 of 4 WML-C95_User_Manual 3. Federal Communications Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 3 Page 3 of 4 WML-C95_User_Manual End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID: EW4C95”.
- Page 4 Page 4 of 4 WML-C95_User_Manual Cet appareil est conçu uniquement pour les intégrateurs OEM dans les conditions suivantes: (Pour utilisation de dispositif module) 1) L'antenne doit être installée de telle sorte qu'une distance de 20 cm est respectée entre l'antenne et les utilisateurs, et 2) Le module émetteur peut ne pas être coïmplanté...
Need help?
Do you have a question about the WML-C95 and is the answer not in the manual?
Questions and answers