Intellitec 00-00563-000 Service Manual

Electric step power selector

Advertisement

ELECTRIC STEP POWER SELECTOR

PRODUCT DESCRIPTION

Th
e Electric Step Power Selector is intended to be used on a motor home to supply power to an electric
step, such as a Kwikee Step. Ideally, the electric step on a motor home would be powered from the coach
battery so that it's use doesn't discharge the chassis battery. However, if the coach battery is dead or
disconnected, the step will fail to operate.
To prevent this from happening, the Power Selector connects to both the chassis and coach batteries to provide
power primarily from the coach battery, but when that battery is low or missing, it provides power to the step
from the chassis battery.
The ELECTRIC STEP POWER SELECTOR is an electronic switching module used to select which
battery will supply power to the electric step of the motor home. Power from the batteries of the vehicle is
available at the connections of this module. Inadvertent shorts at this module could result in damage
and/or injury.
All servicing of this module should be done only by a qualified Service Technician.
Intellitec
www.Intellitec.com
SERVICE MANUAL
ELECTRIC STEP
POWER SELECTOR
by Intellitec
Part No. 00-00563-000
Part Number: 00-00563-000
CAUTION:
Tools required: Low current test light.
1
1485 Jacobs Rd.
Deland, FL 32724
386.738.7307
P/N 53-00563-100 Rev. B 032619

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 00-00563-000 and is the answer not in the manual?

Questions and answers

Summary of Contents for Intellitec 00-00563-000

  • Page 1 SERVICE MANUAL ELECTRIC STEP POWER SELECTOR by Intellitec Part No. 00-00563-000 Part Number: 00-00563-000 PRODUCT DESCRIPTION e Electric Step Power Selector is intended to be used on a motor home to supply power to an electric step, such as a Kwikee Step. Ideally, the electric step on a motor home would be powered from the coach battery so that it’s use doesn’t discharge the chassis battery.
  • Page 2 Power Selector. It should be above 11.2 volts. Re-connect the chassis battery and disconnect the coach battery. Check the operation of the electric step. It should operate normally. 1485 Jacobs Rd. Intellitec Deland, FL 32724 386.738.7307 www.Intellitec.com P/N 53-00563-100 Rev. B 032619...
  • Page 3 - The indicator light in the switch is burned out. Replace the switch. The step operates only when the ignition is turned on. Indicator light in switch doesn’t come on. - Check the 5 Amp fuse in the Power Selector. 1485 Jacobs Rd. Intellitec Deland, FL 32724 386.738.7307 www.Intellitec.com...
  • Page 4 ELECTRIC STEP POWER SELECTOR SERVICE MANUAL Typical Wiring Diagram 1485 Jacobs Rd. Intellitec Deland, FL 32724 386.738.7307 www.Intellitec.com P/N 53-00563-100 Rev. B 032619...

Table of Contents