Advertisement
Connection to Speakers: Remove the remaining WIN600
four-position speaker connectors. Connect the speakers or
volume control inputs to any of the six connectors labeled
"ROOM" again strictly observing polarity. Check out or web
site www.knollsystems.com for information on series and
parallel speaker wiring.
Note: For best sound quality always use Knoll 100%
transformer-free stereo volume controls such as the VC100,
VC100ss or VS100 in each room.
INPUT
ROOM1
ROOM2 ROOM3 ROOM4
Room 4
direct
connection
+
R>
-
-
L>
+
Stereo Amplifier or
CAUTION: WIN600
MAY BE VERY HOT
Stereo Receiver
(THIS IS NORMAL)
"Speaker Outputs"
Operation: The Knöll WIN600 is completely automatic and
does not need any user adjustments after installation.
ROOM5 ROOM6
Room 6 with
stereo volume
control
Speakers
Specifications:
Peak RMS power rating:
Continuous RMS power:
Frequency Response:
Speaker types:
Speaker wiring method:
Speaker impedance:
Grounds
except tube or valve amps. See below.
Connection:
Dimensions:
Color:
Note: When using tube or valve amps, we suggest adding 150 ohm 3
watt resistors in parallel across each amplifier left and right output.
Warranty
Knöll Systems warrants its products sold in the USA and Canada by authorized Knöll
dealers to be free of defects in materials and workmanship. This warranty extends for two
full years from the date of purchase by the original consumer. Any products returned to
Knöll Systems and found to be defective by Knöll Systems within the warranty period
will be repaired or replaced at Knöll Systems option, at no charge. Knöll Systems will not
be responsible for the actual cost of installation or removal of the product, nor for any
incidental or consequential damages. Some states do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights. You may have additional legal rights that
vary from state to state.
The WIN600 has no user replaceable parts.
Knoll Systems
145 Tyee Drive Point Roberts, WA 98281
11791 Machrina Way, #120 Richmond BC V7A 4V3
tel (604) 272 4555, fax (604) 272 5595
www.knollsystems.com
Made in Canada. WIN600 guide.doc 1999-2002 Knoll Systems. All Rights Reserved
300 watts per channel (5 seconds)
200 watts per channel
DC to 500,000 Hz at all power levels
to 350 watts +/- 0.1dB
Most speaker types are acceptable.
Similar and dissimilar speakers can be
used on one interface and each will
sound their best.
Series or parallel wiring is acceptable.
4-16 ohms (single or multi-speakers)
Independent left/right grounds for
safe connection of all amplifier types
Detachable screw terminals capable
of 12-22 awg wire
10-7/8" w x 7-5/8" h x3" d
(27.6x19.4x7.6cm)
White
Advertisement
