Advertisement
VC224pm and VC226pm typical wiring diagram
To have a room or zone
start with the music
on when the VC226pm
powers up, remove the
shunt labelled
S/MUTE. Otherwise
the keypad has to be
pushed or remote
touched to turn on this
room only.
When the sound does
come on (whether or
not S/MUTE is
selected) the sound
always comes on in
position #6 (of 17
total). To make the
music start in this
room only at position
#12, remove the shunt
labelled #6/12.
Connect the
power amplifier's
speaker outputs
to the VC226pm
jack labelled
"INPUT"
Make sure proper
wire polarity is
120 WATT
observed.
MAXIMUM
STEREO
AMPLIFIER
VC226pm Cabinet
INPUT
ROOM1 ROOM2
VC201 Keypad
4-16 OHMS
ROOM #1
Labeled wrong on version 1.3
IR OUT
ROOM3 ROOM4
12vdc 500mA
IR55
Infrared connection
module to emitters
12VDC
ROOM5 ROOM6
Home run
cat 5 wire
VC201 Keypad
Speakers
ROOM #6
Power supply.
Connect to the
switched oulet on
the receiver or
amplifier if
possible
One or two VC201
keypads or one
VC201i keypad can
control each rooms
stereo speakers.
Connect the one or
two VC201 or one
VC201i keypad to
the VC226pm
cabinet's correct
RJ45 8 conductor
connector using a
home run of cat 5
wire. Be sure to
use a good quality
RJ45 8/8 crimper.
Home run
four conductor
speaker wire
Advertisement
