eFOLDi Tyre Inflator User Manual

Tyre Inflator
User Manual

Packing List

1x Inflator
1x Air Tube
1x Presta Valve
Convertor
1x Ball Inflation
Needle
1x USB Charging Cable
1x Storage Bag

About Buttons

Short Press
Long Press

About Inflation

Car
Road Bike
Mountain Bike
Motorcycle
Basketball
*No extrusion during testing

Steps for Inflation

1. Connect one end of the air tube to the inflator, connect the other end to the tyre valve
(for presta valve please install the valve convertor first).
2. Long press the POWER button until the LED screen lights up. The LED will show the current set pressure.
3. Press the UNIT button to choose the pressure unit between PSI, BAR, KPA and kgf/cm².
4. Use the '+' button and '-' button to set the target pressure. The inflator will remember the pressure you set previously.
5. Press the POWER button to start inflating. Pressing it again can pause or continue.
The inflator will stop automatically when it reaches the target pressure.

Using the Torch -

Long press the UNIT button to turn On/Off the LED light.

About Charging

1. For first time use or after a long time of no use please charge the inflator before using.
2. The charging indicator will turn red during charging and the indicator light will turn red and green alternately
when charging is complete.
3. Usually the inflator should be charged every two months even when it will not be used.
If you do not charge the inflator for a long time the battery will be over-discharged and the battery may become damaged.
Details
UNIT 'U' Button - Button
U
Choose Unit Reduce Pressure
Turn On/Off Light Quick Reduce
Reference Pressure
2.3 – 2.5 BAR
100-120 PSI
30-50 PSI
30-50 PSI
7-9 PSI
+ Button LED Screen POWER Button
-
+
Increase Pressure
Quick Increase
Time from Empty (Minutes)
8-12
2-3
2-3
2-3
0.5-1
LED Light
Vent Port
Air Tube Storage
USB Charging
Port
Charging Indicator
Start/Stop Inflating
Turn On/Off
Frequency from Empty
2-3 (205 55R17)
8-12 (700x23C) *
12-18 (26x1.95) *
8-12
30-40