Ca'Bano 30304 Installation Manual

#30304
4 Piece deck mount tub filler with hand shower
INSTALLATION GUIDE
BS01981726
BS01981726
BS02621727
Last revision: October 23rd
l. Installation Notice
1. Please lay water pipes in accordance with this manual.
2. Floor drain should be installed on the site.
3. The product should be installed only after the completion of house
interior decoration in case the paint or other chemicals erode the
mixer surface.
4. Clean pipes to get rid of mud, sand or other debris blocked in pipes
before installation.
5. Check whether the threads can be matched. Otherwise, installing
forcefully will damage the components.
6. After installation, check all the joints to make sure they are firmly
connected. Run the water. Turn on and off repeatedly to ensure no
leaking problem. After that, the product is ready for normal use.
7. Hand the manual to users.
II. Operation Notice
1. The product is used under water pressure 0.05~1.0 MPa, water
temperature 4~90°C.
2. Do not hang heavy things on the product.
3. Remember to turn off the mixer if no water comes out of it
(Especially when nobody in the house or during the decoration period).
4. Clean the surface of the product regularly to keep it glossy. Note: Please
do not use inappropriate tools such as sharp brushes, rough sponges,
scouring pads or corrosive detergent. And it is not recommend to use the
detergent sold in the market, because its formula changes frequently.
Please clean the product with wet cloth and soapy water after usage.
Then rinse the soap off with clean water and dry with a soft cotton cloth.
5. When indoor temperature drops below 0°C, take necessary measures
(Keep the product warm, close windows) to prevent the product from
frost cracking (Especially when windows open for air ventilation while
nobody in the house).
6. Adjust the temperature before use to avoid scald.
7. Do not disassemble the product without help from the professionals.
lll. Installation Diagram
IV. Installation Steps(Fig.1-21)
S2.5 Wrench (supplied)
Philips
Screwdriver
Protection Sheath
Stop Collar
Inlet Valve Body
Plastic Spacer
Locking Washer
Locking Nut
The installation diagram is only for reference.
：
The product is subject to the real object.
Prepare and check the
following tools.
Spanner
Remove the protection sheath
off the two inlet valve bodies.
Take off the stop collar and
screw off the locking nuts to
the bottom.