Tallac Networks ECP100-5P Quick Start Manual

Tallac Networks
ECP100-5P Quick Start Guide
Congratulations on choosing the Tallac SD-BRANCH ECP100-5P
1. Create an new account at cloud.tallac.com, be sure to click on the confirmation email to
complete your registration and login to cloud.tallac.com.
2. Use the
3. Navigate to devices from the left-hand menu and use the
ECP100-5P by entering the serial number that begins with EC followed by 10 numbers, example
EC1828000501.
4. Power on your ECP100-5P with an ethernet cable connected to any of the ethernet ports. Make
sure that the device will receive a DHCP address and can reach the internet.
5. After a few minutes, the device status will change to "Online".
6. Navigate to the "Devices" view in the left-hand menu and select the
sure the device has the most current firmware.
7. Your ECP100-5P is now ready to use.
Recommended first configuration tips
Gateway Configuration & DHCP - If you would like the ECP100-5P to be your gateway, please
follow the instructions under "Support Information – Automation Gateway Configuration & DHCP".
Rules - There are two standard automations and the ability to add custom automations. To
configure standard or custom automations go to the "Rules" tab
information on configuration and configuration steps, please refer to "Support Information".
Ports - You can enable, disable and assign friendly names to the
four Ethernet ports and USB ports. Click on the pencil/tablet icon
to add a friendly name. The ports view controls the networking
functions of the ethernet and USB ports, the power portion of
the POE port is controlled from the Power tab.
The information contained herein is subject to change without notice ,Tallac Networks shall not be liable for technical or editorial errors or omissions contained herein.
button at the top of the home page to create your first site.
© Copyright 2020 Tallac Networks
button to add your
tab and make
. For additional