Specifications - Knoll SP66 Owner's Manual

5. Connect the speaker wire to the SP66 speaker carefully observing
correct speaker terminal polarity.
6. Slip the bottom of the speaker down into the opening cut in the wall
or ceiling, slide the whole speaker into the wall cavity and center the
speaker in the hole. Tighten all six screws (just snug, don't over tighten).
This should allow the speaker to line up and clamp the wall board with
the speaker frame.
7. Turn the amplifier on, room volume controls up and test the speakers.
8. Snap the white (paintable) grill into the SP66 speaker bracket.
Installation: New Construction
1. Run two wires from the amplifier location to the room volume control
(optional) then to the intended speaker location. Loop an extra 1m (3')
of wire out from the ceiling or wall. ID tag the wires.
2. After wall board or sheet rock is installed, make sure the 7-3/4" x11"
speaker hole is cut out correctly then follow steps 4-8 in "Existing
Construction".
Amplifier or Receiver Operation
The amplifer or receiver should provide more power than will be
needed. Always reduce sound levels immediately if sound distortion is
present. Any amplifier, especially low powered amplifiers can damage
speakers when distorted sound (usually you will hear a harsh or unclear
sound) is being reproduced. Speaker damage caused by sound distortion
or gross overpowering is easily evident and is not covered by the
warranty.
Trim Ring Painting
The SP66 speaker baffle and grill can be painted to match any interior
decorating scheme. Ideally paints with nitrocellulose lacquer are used.
Most cold paint types are suitable as well. Primer can be used when
darker colors are required. We do not suggest painting the inner black
cavity or drivers.
SP66 Limited Warranty
Knöll Systems warrants SP66 speakers to be free from defects in
materials and workmanship. This warranty extends for one full year from
the date of purchase by the consumer. Any products returned freight
prepaid to Knöll Systems and found to be defective by Knöll systems
within the warranty period will be repaired or replaced at Knöll Systems
option, at no charge. Knöll Systems will not be responsible for the actual
cost of installation or removal of the product, nor for any consequential
or incidental damages. Some states do not allow the exclusion or limita-
tion of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This warranty gives you specific legal
rights. You may have additional rights which vary from state to state.

Specifications

Speaker Type: 2-way
Woofer: 6-1/2" filled mica
Tweeter: 1" (25mm) Soft dome
Peak Power RMS: 80 watts
Power Rating RMS: 60 watts
Amplifier Power : 5-100 watts/channel
Nominal Impedance: 8 ohms
Sensitivity: 90 dB/W/m
Frequency Range: 50Hz-21kHz
Mount Depth Required: 3-1/4" (90mm)
Dimensions: 12-1/8 8-3/4"
Cut Out Dimensions: 11 x 7-1/2"
Color: Paintable white
Knöll Systems
In Canada:
tel (604) 272-4555
11791 Machrina Way
fax (604) 272-5595
Richmond, B.C. V7A 4V3
SP66
C
Knoll Systems, Richmond, BC Canada
COPYRIGHT 1999, Knöll Systems,
All Rights Reserved
In America:
145 Tyee Drive
Point Roberts, WA 98281