Advertisement
UTP-Send, UTP-Cam or UTP-Decora cam connected to the single RJ45 jack. Do not connect another
power supply to the UTP-Receive or UTP-Send modules as damage not covered by the warranty may
occur. The whole Media System uses very little power and is normally left on. A led lamp shows if power
is connected properly to the UTP-Receive, UTP-Decora Cam and UTP-Send modules.
A 12VDC -15VDC (500mA or more) power supply is connected to the Media System Hub(s) using the
2.1mm connector (center positive) or the screw terminal. If any of the Cat5 wire distances are longer than
300' use a 15VDC-18VDC-power supply.
Dip diagram in media hub install man.p65.
Knoll Systems
145 Tyee Drive Point Roberts, WA 98281
11791 Machrina Way, #120 Richmond BC V7A 4V3
tel (604) 272 4555, fax (604) 272 5595
www.knollsystems.com
Made in Canada. 1999-2002 Media System Hub Knoll Systems. All Rights Reserved
Advertisement
